How To Fix QY056 - Inspection type for origin 15 is not active for material &1/&2

SAP Error Message - Details

• Message type: E = Error

• Message class: QY - QM: Sample management

• Message number: 056

• Message text: Inspection type for origin 15 is not active for material &1/&2

What causes this issue?

In the material master, the inspection type for inspection lot origin 15
(inspection lot for a sample) is not active.

System Response

No inspection lot could be created.

How to fix this error?

Maintain and activate the inspection type 15 (inspection lot for a
sample) in the material master.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QY056 - Inspection type for origin 15 is not active for material &1/&2 ?

  The SAP error message QY056 indicates that the inspection type for a specific origin (in this case, origin 15) is not active for the specified material. This typically occurs in the context of Quality Management (QM) in SAP when you are trying to perform a quality inspection for a material that does not have the required inspection type configured.
  Cause:
  
  Inactive Inspection Type: The inspection type for the specified origin (15) is not activated for the material in question.
  Material Master Configuration: The material master record may not have the necessary quality management settings configured.
  Origin Configuration: The origin (in this case, 15) may not be set up correctly in the system or may not be linked to the inspection type you are trying to use.
  
  Solution:
  
  
  Check Inspection Type Configuration:
  
  Go to the transaction code OMSQ (or navigate through the menu: Logistics > Quality Management > Quality Inspection > Inspection Setup > Inspection Types).
  Verify that the inspection type for origin 15 is active for the material in question.
  
  
  
  Material Master Settings:
  
  Use transaction code MM02 to change the material master record.
  Navigate to the Quality Management view and ensure that the relevant inspection type is assigned and active.
  
  
  
  Activate Inspection Type:
  
  If the inspection type is not active, you may need to activate it. This can be done in the same configuration area where you checked the inspection type.
  
  
  
  Check Origin Configuration:
  
  Ensure that the origin (15) is correctly configured in the system. You can check this in the configuration settings for origins in QM.
  
  
  
  Consult Documentation:
  
  If you are unsure about the settings, refer to SAP documentation or consult with your SAP QM consultant for guidance on how to properly configure inspection types and origins.
  
  
  
  Related Information:
  
  Inspection Types: These are predefined categories of inspections that can be performed on materials. Each inspection type has specific settings and requirements.
  Material Master: This is a central repository of information related to materials in SAP, including data relevant to quality management.
  Quality Management (QM): This module in SAP is responsible for managing quality processes, including inspections, quality planning, and quality control.
  
  By following these steps, you should be able to resolve the error message QY056 and ensure that the inspection type for origin 15 is properly configured for the material in question.