How To Fix UGMD411 - Error while replicating data - see long text

SAP Error Message - Details

• Message type: E = Error

• Message class: UGMD - FIN Master Data: Messages

• Message number: 411

• Message text: Error while replicating data - see long text

What causes this issue?

For field &V1&, attribute mapping &V2&/&V3& was triggered. However, the
data could not be replicated because no database table for attribute
&V4& was found.

System Response

The data could not be replicated.

How to fix this error?

Check whether there are any SAP Notes that you can use to solve the
problem. If you are unable to find a suitable Note, contact SAP.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UGMD411 - Error while replicating data - see long text ?

  The SAP error message UGMD411 typically indicates an issue encountered during the data replication process in the SAP system. This error can arise in various contexts, such as when replicating master data or transactional data between systems (e.g., from SAP ERP to SAP S/4HANA or between different SAP systems).
  Cause:
  The UGMD411 error can be caused by several factors, including but not limited to:
  
  Data Inconsistencies: There may be inconsistencies or errors in the data being replicated, such as missing mandatory fields or incorrect data formats.
  Configuration Issues: Incorrect configuration settings in the data replication framework or related components can lead to replication failures.
  Network Issues: Connectivity problems between the source and target systems can interrupt the replication process.
  Authorization Issues: The user or service account performing the replication may lack the necessary authorizations to access or modify the data.
  System Performance: High system load or performance issues can lead to timeouts or failures during the replication process.
  
  Solution:
  To resolve the UGMD411 error, you can follow these steps:
  
  Check the Long Text: The error message usually has a long text that provides more specific details about the issue. Review this text for clues on what went wrong.
  Validate Data: Ensure that the data being replicated is complete and adheres to the required formats. Check for any missing mandatory fields or invalid data.
  Review Configuration: Verify the configuration settings for the data replication process. Ensure that all necessary settings are correctly defined.
  Check Connectivity: Ensure that there are no network issues between the source and target systems. Test the connection to confirm that it is stable.
  Review Authorizations: Check the user or service account permissions to ensure it has the necessary authorizations to perform the replication.
  Monitor System Performance: Check the performance of both the source and target systems. If there are performance issues, consider optimizing the systems or scheduling replication during off-peak hours.
  Consult Logs: Review system logs (such as application logs or error logs) for additional details that may help identify the root cause of the error.
  
  Related Information:
  
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Documentation: Refer to the official SAP documentation for data replication processes, which may provide insights into common issues and best practices.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, consider reaching out to SAP support for further assistance.