How To Fix UGMD410 - Attribute &2 cannot be mapped to &3 - see long text

UGMD410 - Overview

• Message type: E = Error

• Message class: UGMD - FIN Master Data: Messages

• Message number: 410

• Message text: Attribute &2 cannot be mapped to &3 - see long text

What causes this issue?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

TRANSLATORS! Be sure to retain the original order of the numbered
conditions and sequence of the variables.
You want to assign the remote attribute &V3& to the role attribute &v2&
of field &v1&. This is not possible because in this case the condition
&V4& has been violated.
The following conditions must be met before you can allocate the two
attributes to each other:
To characteristic &v1& you need to assign a role that has a &V2&
attribute.
Characteristics &v1& and &v3& must be remote fields (for example,
InfoObjects); and &v3& must be assigned as an attribute to
characteristic &v1&.
Attributes &v2& and &v3& must have the same <DS:DE.DATATYPE_D>data type
</>.
Attributes &v2& and &v3& must have the same <DS:DE.DDLENG>length</>.
Attributes &v2& and &v3& must have the same <DS:DE.CONVEXIT>conversion
routine</>.
Attributes &v2& and &v3& must have the same time dependencies.
Assignments of remote attributes to role attributes must be injective -
that is, only one remote attribute can be assigned a given role
attribute, and only one role attribute can be assigned to a remote
attribute. The only exception to this is stated under condition 8.
If role attribute &v2& has other kinds of dependencies besides possible
time dependencies, and these other dependencies cannot be modeled with
remote attribute &v3&, you need to confine all of these additional key
fields to unique fixed values when assigning the attribute. In this
case, the assignment only applies to these values of the independent
characteristics. In a case as described here, you can also assign
multiple remote attributes to a single role attribute, but then you need
to confine the respective additional key fields to different fixed
values.
Role attribute &V2& may not be mapped to a predefined fixed name of an
InfoObject. This is because, in this specific case, an implicit
assignment already exists. Thus, it is sufficient to assign, as an
attribute, the InfoObject assigned to &V2& in table <AB>UGBW4000</> to
InfoObject &V1&. If you do this, the system will always automatically
transfer any changes of role attribute &V2& to the SAP BW system, as
well.

System Response

The data basis cannot be saved.

How to fix this error?

Either correct the attribute assignment (as described above), or delete
it.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UGMD410 - Attribute &2 cannot be mapped to &3 - see long text ?

  The SAP error message UGMD410 indicates that there is an issue with mapping an attribute in the context of a data model or a data transfer process. This error typically arises when the system is unable to map a specific attribute (denoted as &2) to a target structure or field (denoted as &3). The long text of the error message usually provides more detailed information about the specific context and potential causes.
  Causes:
  
  Data Model Mismatch: The attribute you are trying to map may not exist in the target data model or structure.
  Incorrect Configuration: There may be a configuration issue in the mapping settings, such as incorrect field names or types.
  Data Type Incompatibility: The data types of the source attribute and the target attribute may not be compatible.
  Missing Attributes: The attribute you are trying to map might not be defined in the source or target data structure.
  Versioning Issues: If there are different