How To Fix T5059 - Error deleting old work center settings

SAP Error Message - Details

• Message type: E = Error

• Message class: T5 - SAPphone: Messages for telephony

• Message number: 059

• Message text: Error deleting old work center settings

What causes this issue?

The work center-dependent settings should be saved under a new work
center ID. The old settings must be deleted and created again with the
new work center ID. An error occurred while the old settings were being
deleted and as a result, the settings could not be deleted.

System Response

Function canceled.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message T5059 - Error deleting old work center settings ?

  The SAP error message T5059, which indicates an issue with deleting old work center settings, typically arises in the context of work center management within the SAP system. This error can occur for various reasons, and understanding the cause and potential solutions is essential for resolving the issue.
  Cause:
  
  Dependencies: The work center may have dependencies or references in other modules (like production orders, maintenance orders, etc.) that prevent it from being deleted.
  Data Integrity: The system may be enforcing data integrity rules that prevent the deletion of work center settings that are still in use.
  Authorization Issues: The user may not have the necessary authorizations to delete or modify work center settings.
  Configuration Issues: There may be configuration settings that are preventing the deletion of the work center.
  
  Solution:
  
  
  Check Dependencies: 
  
  Review any existing production orders, maintenance orders, or other references that may be linked to the work center. You can use transaction codes like CO03 (Display Production Order) or IW33 (Display Maintenance Order) to check for dependencies.
  If there are active orders, you may need to complete or delete them before you can delete the work center settings.
  
  
  
  Review Authorizations: 
  
  Ensure that the user attempting to delete the work center has the necessary authorizations. You may need to consult with your SAP security team to verify and adjust user roles if necessary.
  
  
  
  Use Transaction Codes: 
  
  Use transaction code CR02 (Change Work Center) to check the status of the work center and see if there are any settings that need to be adjusted before deletion.
  If you are trying to delete a work center, you can use CR03 (Display Work Center) to review its details.
  
  
  
  Check Configuration Settings: 
  
  Review the configuration settings in the SAP system related to work centers. Ensure that there are no settings that prevent deletion.
  You may need to consult with your SAP configuration team or refer to the SAP documentation for guidance on work center settings.
  
  
  
  Consult SAP Notes: 
  
  Check the SAP Support Portal for any relevant SAP Notes that may address this specific error message. There may be patches or updates that resolve known issues.
  
  
  
  Contact SAP Support: 
  
  If the issue persists after checking the above points, consider reaching out to SAP Support for further assistance. Provide them with the error message details and any relevant transaction codes you have used.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as CR01 (Create Work Center), CR02 (Change Work Center), and CR03 (Display Work Center).
  Documentation: Review SAP documentation related to work center management for best practices and guidelines.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify the cause of the T5059 error and implement a solution to resolve it.