How To Fix QI119 - Characteristic w/ confirmation no. & could not be valuated

SAP Error Message - Details

• Message type: E = Error

• Message class: QI - Notifications for interface modules for connecting subsyst.

• Message number: 119

• Message text: Characteristic w/ confirmation no. & could not be valuated

What causes this issue?

The inspection characteristic with the confirmation number &V1& could
not be valuated.
This could be caused by one of the following reasons:
in case of an attributive valuation, not enough values were recorded.
the inspection result is not valid.

How to fix this error?

If the cause of the error is unknown, you can display a more detailed
error analysis by selecting the function <LS>Valuate</> in the
transaction for results recording.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QI119 - Characteristic w/ confirmation no. & could not be valuated ?

  The SAP error message QI119 ("Characteristic w/ confirmation no. & could not be valuated") typically occurs in the context of Quality Management (QM) when dealing with inspection lots and characteristics that are expected to be evaluated but cannot be due to various reasons. Here’s a breakdown of the potential causes, solutions, and related information for this error:
  Causes:
  
  Missing Value Assignment: The characteristic in question may not have a value assigned during the confirmation process.
  Incorrect Configuration: The characteristic may not be properly configured in the system, leading to issues during the valuation process.
  Data Inconsistencies: There may be inconsistencies in the data related to the inspection lot or the characteristics being evaluated.
  Characteristic Type: The characteristic might be of a type that does not allow for valuation in the current context (e.g., qualitative vs. quantitative).
  Authorization Issues: The user may not have the necessary authorizations to perform the valuation for the characteristic.
  
  Solutions:
  
  Check Characteristic Assignment: Ensure that the characteristic is correctly assigned to the inspection lot and that it has a value assigned.
  Review Configuration: Verify the configuration settings for the characteristic in the Quality Management module. Ensure that it is set up to allow for valuation.
  Inspect Data: Look for any inconsistencies in the data related to the inspection lot. This includes checking the status of the lot and the values assigned to the characteristics.
  Re-evaluate the Characteristic: If the characteristic is qualitative, ensure that the correct qualitative values are being used. If it is quantitative, ensure that the measurement units and ranges are correctly defined.
  Check Authorizations: Ensure that the user has the necessary permissions to perform the valuation for the characteristic. This may involve checking user roles and authorizations in the SAP system.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes such as QA32 (for displaying inspection lots) or QA11 (for recording results) to investigate the issue further.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Documentation: Review the SAP documentation related to Quality Management and characteristics to ensure that you are following the correct procedures for valuation.
  
  If the issue persists after checking these areas, it may be beneficial to consult with your SAP support team or refer to SAP community forums for additional insights and assistance.