How To Fix QA079 - & were found for distributed inspection types

SAP Error Message - Details

• Message type: E = Error

• Message class: QA - QM : Inspection lots

• Message number: 079

• Message text: & were found for distributed inspection types

What causes this issue?

You have triggered the distribution of the inspection setup by sending
directly.

System Response

The system uses the selection criteria to find the &v1& inspection
types which should be sent as IDOCs using ALE. If you have not
specified a target system on the entry screen, the system tries to
determine one or more receiving systems using the distribution model
with the message category MATQM or BAPI. If at least one recipient is
found, the inspection setup data is distributed to this recipient. If
no recipient could be determined, the system cannot distribute the
data.
&NOTE&
We recommend that you create a model view for the BAPI <ZH>SaveReplica
</> of the <ZH>MatInspectionControl</> object in the distribution
model. Otherwise, distribution is not possible through the evaluation
of change pointers.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QA079 - & were found for distributed inspection types ?

  The SAP error message QA079 typically indicates that there are issues related to the configuration or processing of distributed inspection types in the Quality Management (QM) module. This error can occur when the system is unable to find the appropriate inspection type for the material or when there are inconsistencies in the configuration.
  Cause of Error QA079:
  
  Missing Inspection Type: The specified inspection type may not be defined for the material or the plant in question.
  
  Configuration Issues: There may be issues with the configuration of the inspection types in the Quality Management settings.
  Material Master Data: The material master data may not be set up correctly, particularly in the Quality Management view.
  Distribution Issues: If the inspection type is supposed to be distributed from another system or client, there may be issues with the distribution setup.
  
  Solutions:
  
  
  Check Inspection Type Configuration:
  
  Go to the transaction code SPRO and navigate to the Quality Management settings.
  Ensure that the inspection