How To Fix PLM_AUDIT054 - The degree of fulfillment was set to 0%

SAP Error Message - Details

• Message type: E = Error

• Message class: PLM_AUDIT - PLM Audit Management: Audit Specific Messages

• Message number: 054

• Message text: The degree of fulfillment was set to 0%

What causes this issue?

&V2& points have been subtracted from the determined maximum number of
points for the audit &V1&. The result is less than zero.

System Response

The degree of fulfillment has been set to 0%.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PLM_AUDIT054 - The degree of fulfillment was set to 0% ?

  The SAP error message PLM_AUDIT054, which states "The degree of fulfillment was set to 0%," typically occurs in the context of Product Lifecycle Management (PLM) and is related to the audit process or the management of product data. This error indicates that the system has detected that the degree of fulfillment for a particular task, process, or requirement has been set to zero, which may not be acceptable based on the business logic or configuration.
  Cause:
  
  Incomplete Data Entry: The degree of fulfillment may have been set to 0% due to incomplete or incorrect data entry in the relevant fields.
  Configuration Issues: There may be configuration settings in the PLM module that dictate how fulfillment degrees are calculated or displayed.
  Business Logic Violations: The business rules defined in the system may not allow for a 0% fulfillment degree in certain scenarios.
  Missing Dependencies: There may be dependencies or prerequisites that have not been met, leading to a 0% fulfillment status.
  
  Solution:
  
  Review Data Entry: Check the relevant entries in the system to ensure that all required fields are filled out correctly. Look for any missing or incorrect data that could lead to a 0% fulfillment.
  Check Configuration: Review the configuration settings in the PLM module to ensure that they are set up correctly. This may involve consulting with a system administrator or SAP consultant.
  Business Rules Review: Verify the business rules and logic that govern the degree of fulfillment. Ensure that the current scenario aligns with these rules.
  Dependencies Check: Identify any dependencies that may need to be fulfilled before the degree of fulfillment can be set to a non-zero value. Address any outstanding issues.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance related to the PLM_AUDIT054 error message.
  Contact Support: If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Transaction Codes: Familiarize yourself with relevant transaction codes in SAP PLM that may help in diagnosing or resolving the issue (e.g., transaction codes related to audit management).
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.