How To Fix GPDPEG209 - MD04: PREQ &3 dropped because MRP group not found for material

SAP Error Message - Details

• Message type: E = Error

• Message class: GPDPEG - A&D GPD message classed used by Pegging only

• Message number: 209

• Message text: MD04: PREQ &3 dropped because MRP group not found for material

What causes this issue?

No MRP group maintained for material &V4& in plant &V1&.
Grouping WBS element: &V2&
Purchase requisition: &V3&

System Response

Purchase requisition &V3& not taken into consideration during pegging.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GPDPEG209 - MD04: PREQ &3 dropped because MRP group not found for material ?

  The SAP error message GPDPEG209, which states "MD04: PREQ &3 dropped because MRP group not found for material," typically occurs in the context of Material Requirements Planning (MRP) when the system cannot find a valid MRP group for a specific material. This can prevent the system from processing planned requirements (PREQ) for that material.
  Cause:
  
  Missing MRP Group: The most common cause of this error is that the material in question does not have an MRP group assigned in its material master record.
  Incorrect Configuration: The MRP group may have been incorrectly configured or deleted in the system.
  Material Type Restrictions: Certain material types may not be allowed to have MRP groups assigned, leading to this error.
  Data Inconsistencies: There may be inconsistencies in the data, such as missing or incorrect entries in the relevant tables.
  
  Solution:
  
  
  Check Material Master Record:
  
  Go to transaction code MM03 (Display Material) and enter the material number.
  Navigate to the MRP views (usually MRP 1, MRP 2, etc.) and check if an MRP group is assigned.
  If it is missing, you can assign an appropriate MRP group using transaction code MM02 (Change Material).
  
  
  
  Verify MRP Group Configuration:
  
  Ensure that the MRP group exists in the system. You can check this in the configuration settings under SPRO -> Production -> Material Requirements Planning -> MRP Group.
  If the MRP group is missing or incorrectly configured, you may need to create or adjust it.
  
  
  
  Check Material Type Settings:
  
  Ensure that the material type allows for MRP processing and that it is correctly set up in the system.
  
  
  
  Review MRP Settings:
  
  Check the overall MRP settings in the system to ensure that they are correctly configured for the materials you are working with.
  
  
  
  Run MRP Again:
  
  After making the necessary changes, run the MRP process again to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  MM03: Display Material
  MM02: Change Material
  MD04: Stock/Requirements List
  MD01: MRP Run
  
  
  MRP Group: This is a key configuration in MRP that determines how the system plans for materials. It can affect various parameters such as lead times, lot sizes, and planning strategies.
  Material Master: The material master record contains all the information related to a material, including its MRP settings.
  
  By following these steps, you should be able to resolve the GPDPEG209 error and ensure that the MRP process can proceed without issues.