How To Fix GPDPEG208 - MD04: PLO &3 dropped because MRP group not found for material

GPDPEG208 - Overview

• Message type: E = Error

• Message class: GPDPEG - A&D GPD message classed used by Pegging only

• Message number: 208

• Message text: MD04: PLO &3 dropped because MRP group not found for material

What causes this issue?

No MRP group maintained for material &V4& in plant &V1&.
Grouping WBS element: &V2&
Planned order: &V3&

System Response

Planned order &V3& not taken into consideration during pegging.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GPDPEG208 - MD04: PLO &3 dropped because MRP group not found for material ?

  The SAP error message GPDPEG208, which states "MD04: PLO &3 dropped because MRP group not found for material," typically occurs in the context of Material Requirements Planning (MRP) when the system is unable to find a valid MRP group for a specific material. This can prevent the system from processing the material correctly in MRP runs.
  
  Cause:
  
  Missing MRP Group: The most common cause of this error is that the material in question does not have an MRP group assigned in its material master data.
  Incorrect Configuration: The MRP group may have been deleted or not configured properly in the system.
  Material Type Restrictions: Certain material types may not have MRP groups assigned by default, leading to this error.
  Data Migration Issues: If data was migrated from another system, the MRP group might not have been transferred correctly.
  
  
  Solution:
  
  
  Check Material Master Data:
  
  Go to the material master record (transaction code MM03).
  Check the MRP 1 view to see