How To Fix GPDPEG211 - MD04: PPO &3 dropped because MRP group not found for material

SAP Error Message - Details

• Message type: E = Error

• Message class: GPDPEG - A&D GPD message classed used by Pegging only

• Message number: 211

• Message text: MD04: PPO &3 dropped because MRP group not found for material

What causes this issue?

No MRP group maintained for material &V4& in plant &V1&.
Grouping WBS element: &V2&
Production order: &V3&

System Response

Production order &V3& not taken into consideration during pegging.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GPDPEG211 - MD04: PPO &3 dropped because MRP group not found for material ?

  The SAP error message GPDPEG211, which states "MD04: PPO &3 dropped because MRP group not found for material," typically occurs in the context of Material Requirements Planning (MRP) when the system cannot find a valid MRP group for a specific material. This can prevent the system from processing the material correctly in MRP runs.
  Cause:
  
  Missing MRP Group: The most common cause of this error is that the material in question does not have an MRP group assigned in its material master data.
  Incorrect Configuration: The MRP group may have been deleted or not configured properly in the system.
  Material Master Data Issues: The material master record may be incomplete or incorrectly maintained, leading to the absence of an MRP group.
  Plant-Specific Settings: The MRP group may not be assigned for the specific plant where the material is being processed.
  
  Solution:
  
  
  Check Material Master Data:
  
  Go to transaction code MM03 (Display Material) and enter the material number.
  Check the MRP 1 view to see if an MRP group is assigned. If it is missing, you will need to assign a valid MRP group.
  
  
  
  Assign MRP Group:
  
  If the MRP group is missing, you can assign it by using transaction code MM02 (Change Material).
  Navigate to the MRP 1 view and enter a valid MRP group for the material.
  
  
  
  Verify MRP Group Configuration:
  
  Ensure that the MRP group exists in the system. You can check this in the configuration settings under SPRO -> Production -> Material Requirements Planning -> MRP Group.
  If the MRP group is missing or incorrectly configured, you may need to create or modify it.
  
  
  
  Check Plant-Specific Settings:
  
  If the material is plant-specific, ensure that the MRP group is assigned for the specific plant in the material master.
  
  
  
  Run MRP Again:
  
  After making the necessary changes, run the MRP process again to see if the error persists.
  
  
  
  Related Information:
  
  MRP Groups: MRP groups are used to categorize materials for planning purposes. They determine how MRP calculations are performed for the materials assigned to them.
  Transaction Codes:
  
  MM03: Display Material Master
  MM02: Change Material Master
  MD04: Stock/Requirements List
  MD01: MRP Run
  
  
  Documentation: Refer to SAP Help documentation for detailed information on MRP configuration and material master data management.
  
  By following these steps, you should be able to resolve the GPDPEG211 error and ensure that the material can be processed correctly in MRP.