How To Fix GK668 - One or more cons groups do not have any cons unit assignments

SAP Error Message - Details

• Message type: E = Error

• Message class: GK - Messages for SAP Consolidation

• Message number: 668

• Message text: One or more cons groups do not have any cons unit assignments

What causes this issue?

At least one consolidation unit must be assigned (directly or
indirectly) to a given consolidation group. The following consolidation
groups do not have any consolidation units:
&V1&

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Assign at least one consolidation unit either directly to each
consolidation group or (indirectly) to one of the lower-level
consolidation groups.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GK668 - One or more cons groups do not have any cons unit assignments ?

  The SAP error message GK668 indicates that one or more consumption groups (cons groups) do not have any consumption unit assignments. This typically occurs in the context of SAP's Controlling (CO) module, particularly when dealing with cost center accounting or internal orders.
  Cause:
  
  Missing Assignments: The primary cause of this error is that the consumption groups have not been properly assigned to any consumption units. This can happen if the configuration is incomplete or if the necessary assignments were not made during the setup process.
  Configuration Issues: There may be issues in the configuration of the consumption groups or the related master data.
  Data Inconsistencies: There could be inconsistencies in the data, such as missing or incorrect entries in the relevant tables.
  
  Solution:
  
  
  Check Consumption Group Configuration:
  
  Navigate to the configuration settings for consumption groups in the SAP system.
  Ensure that all necessary consumption groups are defined and that they have valid consumption unit assignments.
  
  
  
  Assign Consumption Units:
  
  Go to the relevant transaction (e.g., OKB9 for cost center accounting) and check the assignments of consumption units to the consumption groups.
  If any consumption groups are missing assignments, add the necessary consumption units.
  
  
  
  Review Master Data:
  
  Check the master data for cost centers, internal orders, or any other relevant objects to ensure that they are correctly set up and linked to the appropriate consumption groups.
  
  
  
  Run Consistency Checks:
  
  Use transaction codes like KAH2 (for cost centers) or KSB1 (for cost center reports) to run consistency checks and identify any discrepancies in the data.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on configuring consumption groups and units.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the configuration and assignments, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as OKB9 (for consumption group configuration), KAH2 (for cost center master data), and KSB1 (for cost center reports).
  SAP Notes: Check for any SAP Notes related to this error message, as they may provide additional insights or patches that address known issues.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to resolve the GK668 error and ensure that your consumption groups are properly configured and assigned.