How To Fix GC433 - Period & is included in multiple intervals

SAP Error Message - Details

• Message type: E = Error

• Message class: GC - Error Messages for Consolidation/Extended General Ledger

• Message number: 433

• Message text: Period & is included in multiple intervals

What causes this issue?

The period intervals overlap period &V1&

System Response

Information

How to fix this error?

In order for Consolidation to execute properly, you must seperate the
intervals.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GC433 - Period & is included in multiple intervals ?

  The SAP error message GC433 indicates that a specific period is included in multiple intervals, which typically occurs in the context of planning or budgeting within SAP. This error can arise when you are trying to assign a period to multiple planning intervals or when there is a conflict in the configuration of your planning cycles.
  Cause:
  
  Overlapping Intervals: The period you are trying to assign is already included in another planning interval, leading to a conflict.
  Configuration Issues: There may be issues in the configuration of your planning cycles or intervals that allow for overlapping periods.
  Data Entry Errors: Incorrect data entry while defining planning intervals or periods can lead to this error.
  
  Solution:
  
  Check Planning Intervals: Review the planning intervals defined in your system. Ensure that the period in question is not included in multiple intervals. You may need to adjust the intervals to eliminate overlaps.
  Modify Configuration: If the intervals are configured incorrectly, you may need to modify the configuration settings in the relevant planning application (e.g., SAP BPC, SAP S/4HANA).
  Data Validation: Validate the data entries for the planning intervals to ensure that there are no mistakes or overlaps.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on managing planning intervals and periods.
  Seek Support: If the issue persists, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  Related Information:
  
  Transaction Codes: Depending on your SAP version, you may use transaction codes like KP06 (Cost Center Planning) or CNS0 (Planning Layouts) to review and adjust planning intervals.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to resolve the GC433 error and ensure that your planning intervals are correctly configured without overlaps.