How To Fix EHSBATLVAL014 - Process parameter description is not permitted for specification type &1

EHSBATLVAL014 - Overview

• Message type: E = Error

• Message class: EHSBATLVAL - Messages for Table-Based Value Assignment

• Message number: 014

• Message text: Process parameter description is not permitted for specification type &1

What causes this issue?

The selected process parameter description has not been assigned to the
profile of specification type &V1&.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Choose a description that has been assigned to the profile. If you want
to use the process parameter description for specification type &V1&,
notify your system administrator.

Procedure for System Administrators

Check the settings in
Customizing for <LS>Recipe Management</> and change them if required.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHSBATLVAL014 - Process parameter description is not permitted for specification type &1 ?

  The SAP error message EHSBATLVAL014 indicates that there is an issue with the process parameter description for a specific specification type in the SAP Environment, Health, and Safety (EHS) module. This error typically arises when the system encounters a process parameter that is not allowed for the specified specification type.
  
  Cause:
  The error can occur due to several reasons:
  
  Incorrect Specification Type: The specification type you are trying to use may not support process parameters.
  
  Configuration Issues: There may be a misconfiguration in the EHS settings or in the specification type definitions.
  Data Entry Errors: The data entered for the process parameters may not conform to the expected format or requirements for the specified type.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Specification Type:
  
  Verify that the specification type you are using is indeed intended to support process parameters. You can do this by checking the configuration settings in the EHS module.
  
  
  
  Review Process Parameters:
  
  Ensure