How To Fix EHSB_RC144 - Limit value in constraint of type &2 is not defined in specification &1

SAP Error Message - Details

• Message type: E = Error

• Message class: EHSB_RC - Compliance Check

• Message number: 144

• Message text: Limit value in constraint of type &2 is not defined in specification &1

What causes this issue?

The limit value of a constraint of constraint type &v2& in the
substance with constraints &v1& has not been defined.
This message is triggered in the set of rules.

System Response

The system cannot perform the compliance check.

How to fix this error?

Check the constraints of constraint type &v2& in the substance with
constraints &v1& and ensure that all constraints of this constraint type
have a limit value.
&hint&
The meaning of the technical key &v2& is defined in phrase mapping of
the set of rules.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHSB_RC144 - Limit value in constraint of type &2 is not defined in specification &1 ?

  The SAP error message EHSB_RC144 indicates that there is a problem with a limit value in a constraint of a specific type that is not defined in the corresponding specification. This error typically arises in the context of SAP's Environment, Health, and Safety (EHS) module, particularly when dealing with substance specifications, safety data sheets, or regulatory compliance.
  Cause:
  The error can occur due to several reasons:
  
  Missing Limit Values: The limit value for a specific constraint type is not defined in the material specification or the relevant regulatory framework.
  Incorrect Configuration: The configuration of the constraints or limit values may be incorrect or incomplete.
  Data Inconsistency: There may be inconsistencies in the data entered for the material or substance specifications.
  Specification Not Active: The specification might not be active or properly assigned to the material.
  
  Solution:
  To resolve the EHSB_RC144 error, you can take the following steps:
  
  
  Check Specification:
  
  Go to the specification in question (using transaction codes like CG02 for material specifications).
  Verify that the limit values for the relevant constraints are defined correctly.
  
  
  
  Define Missing Limit Values:
  
  If the limit value is missing, you need to define it. This can be done by editing the specification and adding the necessary limit values for the constraints.
  
  
  
  Review Constraint Types:
  
  Ensure that the constraint types used in the specification are correctly configured and that they match the expected values.
  
  
  
  Activate Specification:
  
  Make sure that the specification is active and properly assigned to the material or substance.
  
  
  
  Data Consistency Check:
  
  Perform a data consistency check to identify any other potential issues that may be causing the error.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on the constraints and limit values relevant to your industry or regulatory requirements.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as CG02 (Change Material Specification), CG03 (Display Material Specification), and EHS-related transactions.
  EHS Configuration: Understanding the configuration settings for EHS in your SAP system can help in troubleshooting similar issues.
  Regulatory Compliance: Ensure that your specifications comply with relevant regulations, as this can impact the definitions of limit values and constraints.
  
  By following these steps, you should be able to identify and resolve the cause of the EHSB_RC144 error in your SAP system.