How To Fix EHSB_RC145 - Exception value in constraint of type &2 not defined in specification &1

EHSB_RC145 - Overview

• Message type: E = Error

• Message class: EHSB_RC - Compliance Check

• Message number: 145

• Message text: Exception value in constraint of type &2 not defined in specification &1

What causes this issue?

The exception value of a constraint of constraint type &v2& in the
substance with constraints &v1&, has not been defined.
This message is triggered in the set of rules.

System Response

The system cannot perform the compliance check.

How to fix this error?

Check the constraints of constraint type &v2& in the substance with
constraints &v1& and ensure that all constraints of this constraint type
have exception values to be checked.
&hint&
The meaning of the technical key &v2& is defined in phrase mapping of
the set of rules.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

EHSB_RC145 - Details

• The SAP error message EHSB_RC145 typically occurs in the context of SAP Environment, Health, and Safety (EHS) when there is an issue with the constraints defined for a specific specification. This error indicates that there is an exception value in a constraint of a certain type that has not been defined in the corresponding specification.
  
  Cause:
  
  Missing Definition: The exception value for the constraint type is not defined in the specification. This can happen if the specification was not properly set up or if there are missing entries in the relevant tables.
  Incorrect Configuration: There may be a misconfiguration in the EHS settings or the specification itself, leading to the system not recognizing the exception value.
  Data Inconsistency: There could be inconsistencies in the data, such as changes made to the specification or constraints that were not properly updated.
  
  
  Solution:
  
  Check Specification: Verify that the specification (identified by &1 in the error message) is correctly defined