How To Fix CMS_MOV008 - Number range object &1 not defined; contact your system administrator

CMS_MOV008 - Overview

• Message type: E = Error

• Message class: CMS_MOV - Message Class for Movables

• Message number: 008

• Message text: Number range object &1 not defined; contact your system administrator

What causes this issue?

An internal error has occurred with the number range settings for the
collateral object type. The function modules of number ranges are unable
to read the number range object defined for the collateral object from
table <ZH>TNRO</>.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Run a check for the number range object definition in transaction
<ZH>SNRO</>. If the object does not exist, then send requisition for the
same to SAP.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CMS_MOV008 - Number range object &1 not defined; contact your system administrator ?

  The SAP error message CMS_MOV008 indicates that a number range object is not defined in the system. This typically occurs when the system attempts to generate a number for a document or transaction, but the corresponding number range object has not been set up or is not properly configured.
  
  Cause:
  
  Missing Number Range Object: The specified number range object (&1) is not defined in the system.
  
  Configuration Issues: The number range object may exist but is not properly configured (e.g., no intervals defined).
  Authorization Issues: The user may not have the necessary authorizations to access or use the number range object.
  Transport Issues: If the configuration was transported from another system, it may not have been transported correctly.
  
  
  Solution:
  
  
  Check Number Range Object:
  
  Use transaction code SNRO to check if the number range object exists.
  Enter the object name (the value of &1 in the error message) and check if it is defined.
  
  
  
  Define Number Range:
  
  If the number range object