How To Fix UPS1108 - &2: Attributes are not maintained for any planning session for subplan &1

SAP Error Message - Details

• Message type: E = Error

• Message class: UPS1 - SEM-BPS Status and Tracking System Messages

• Message number: 108

• Message text: &2: Attributes are not maintained for any planning session for subplan &1

What causes this issue?

Attributes have not been maintained in the STS for any planning session
for the subplan specified. Therefore the system assumes that no comments
exist for the specified selection either.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UPS1108 - &2: Attributes are not maintained for any planning session for subplan &1 ?

  The SAP error message UPS1108 indicates that attributes are not maintained for any planning session for a specific subplan. This error typically arises in the context of SAP Integrated Business Planning (IBP) or SAP Advanced Planning and Optimization (APO) when trying to execute a planning function or process that requires certain attributes to be defined for a planning session.
  Cause:
  
  Missing Attributes: The primary cause of this error is that the required attributes for the specified subplan are not defined or maintained in the system.
  Incorrect Configuration: There may be a configuration issue where the planning session does not have the necessary attributes linked to it.
  Subplan Issues: The subplan specified in the error message may not be properly set up or may not have been activated.
  
  Solution:
  
  
  Check Planning Session Configuration:
  
  Go to the planning session configuration in SAP IBP or APO.
  Ensure that the required attributes are defined for the planning session associated with the specified subplan.
  
  
  
  Maintain Attributes:
  
  If attributes are missing, you need to maintain them. This can typically be done in the planning area settings or the planning session settings.
  Navigate to the relevant configuration area and add the necessary attributes for the subplan.
  
  
  
  Validate Subplan Setup:
  
  Ensure that the subplan is correctly configured and activated. Check if it is linked to the correct planning area and that all necessary settings are in place.
  
  
  
  Check Authorization:
  
  Ensure that you have the necessary authorizations to view and modify the planning session and its attributes.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on maintaining attributes for planning sessions in your version of SAP.
  
  
  
  Testing:
  
  After making the necessary changes, test the planning function or process again to ensure that the error is resolved.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Community Forums: SAP Community and other forums can be helpful for finding similar issues faced by other users and their solutions.
  Training and Documentation: If you are unfamiliar with the configuration process, consider reviewing training materials or documentation related to SAP IBP or APO planning sessions.
  
  By following these steps, you should be able to resolve the UPS1108 error and ensure that your planning sessions are correctly configured with the necessary attributes.