How To Fix UCMI100 - Only a key figure-type of attribute can be used for the tax rate

UCMI100 - Overview

• Message type: E = Error

• Message class: UCMI - Messages for Breakdown Category, Item, Document Type, ...

• Message number: 100

• Message text: Only a key figure-type of attribute can be used for the tax rate

What causes this issue?

You have created a mapping setting that stores the tax rate in attribute
&V1&. To accommodate this, attribute &V1& needs to be a key figure with
the type <ZK>floating point number</>. However, this is not the case.

System Response

The changes cannot be saved.

How to fix this error?

Change the mapping setting or the definition of InfoObject &V1&.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UCMI100 - Only a key figure-type of attribute can be used for the tax rate ?

  The SAP error message UCMI100 indicates that there is an issue with the configuration of a tax rate in the context of a key figure in SAP. This error typically arises when a non-key figure attribute is being used where a key figure-type attribute is required for tax rate calculations.
  
  Cause:
  The error occurs due to one of the following reasons:
  
  Incorrect Attribute Type: The attribute you are trying to use for the tax rate is not defined as a key figure in the data model. In SAP, tax rates must be associated with key figures, which are numerical values that can be aggregated.
  Data Model Configuration: The data model or the InfoObject configuration may not be set up correctly, leading to the use of an inappropriate attribute type for tax rates.
  
  
  Solution:
  To resolve the UCMI100 error, you can take the following steps:
  
  
  Check Attribute Configuration:
  
  Go to the SAP BW or SAP HANA modeling environment.
  Verify the