How To Fix UCF7630 - Stop Here indicator is set for both activities in rows &1 and &2

UCF7630 - Overview

• Message type: E = Error

• Message class: UCF7 - Messages for Flexible Upload

• Message number: 630

• Message text: Stop Here indicator is set for both activities in rows &1 and &2

What causes this issue?

You are using the local activity sort. When this is done and there is
only one activity, the <LS>Stop Here</> indicator needs to be set for
each separate investee unit. However, the <LS>Stop Here</> indicator has
been set for two activities in rows &V1& and &V2& for the same investee
unit.

System Response

No data will be posted.

How to fix this error?

Review the log to check the accuracy of the data.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UCF7630 - Stop Here indicator is set for both activities in rows &1 and &2 ?

  The SAP error message UCF7630, which states "Stop Here indicator is set for both activities in rows &1 and &2," typically occurs in the context of project management or activity planning within SAP. This error indicates that there are two activities in a project that are both marked as "Stop Here," which creates a conflict because the system cannot determine which activity should be the stopping point.
  
  Cause:
  The primary cause of this error is that both activities in question have been configured with the "Stop Here" indicator. This can happen due to:
  
  Incorrect configuration of the project activities.
  Manual errors during the setup of the project or activities.
  Overlapping dependencies or constraints that lead to both activities being marked as stopping points.
  
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Identify the Activities: Check the activities referenced in the error message (rows &1 and &2). You can do this by looking at the project structure