How To Fix SI108 - No view can be generated of the procedure model activities

SAP Error Message - Details

• Message type: E = Error

• Message class: SI - Implementation Guide - Status control

• Message number: 108

• Message text: No view can be generated of the procedure model activities

What causes this issue?

The result of the project analysis contains only activities from the
R/3 Procedure Model. No project view can be generated for these
activities.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SI108 - No view can be generated of the procedure model activities ?

  The SAP error message SI108, which states "No view can be generated of the procedure model activities," typically occurs in the context of SAP BusinessObjects or SAP BW when there is an issue with the procedure model or the underlying data model. Here are some common causes, solutions, and related information for this error:
  Causes:
  
  Missing or Incomplete Data Model: The procedure model may not have all the necessary components or data sources defined, leading to an inability to generate a view.
  Incorrect Configuration: There may be configuration issues in the procedure model, such as incorrect parameters or settings that prevent the view from being generated.
  Data Source Issues: The data sources linked to the procedure model might be unavailable, misconfigured, or not properly defined.
  Permissions Issues: The user may not have the necessary permissions to access the data or the procedure model.
  Version Compatibility: There may be compatibility issues between different versions of SAP components or between SAP and third-party tools.
  
  Solutions:
  
  Check Data Model Completeness: Ensure that all necessary components of the procedure model are defined and correctly configured. Verify that all data sources are available and properly linked.
  Review Configuration Settings: Go through the configuration settings of the procedure model to ensure that all parameters are set correctly. Look for any discrepancies or missing configurations.
  Validate Data Sources: Check the status of the data sources used in the procedure model. Ensure they are active and accessible. Test the connections to confirm they are working as expected.
  User Permissions: Verify that the user encountering the error has the appropriate permissions to access the procedure model and the underlying data sources. Adjust permissions as necessary.
  Consult Documentation: Refer to SAP documentation or support resources for specific guidance related to the version of SAP you are using. There may be known issues or patches available.
  Recreate the Procedure Model: If the issue persists, consider recreating the procedure model from scratch to ensure that all components are correctly defined.
  
  Related Information:
  
  SAP Notes and Knowledge Base Articles: Check SAP's support portal for any relevant notes or articles that address the SI108 error specifically.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed. Other users may have encountered the same error and found solutions.
  SAP Support: If the issue cannot be resolved through the above steps, consider reaching out to SAP support for assistance. Provide them with detailed information about the error and the context in which it occurs.
  
  By following these steps, you should be able to diagnose and resolve the SI108 error in your SAP environment.