How To Fix /SAPMP/PP_SFC027 - There is more than one operation &1 with work center &2 in order &3

SAP Error Message - Details

• Message type: E = Error

• Message class: /SAPMP/PP_SFC -

• Message number: 027

• Message text: There is more than one operation &1 with work center &2 in order &3

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /SAPMP/PP_SFC027 - There is more than one operation &1 with work center &2 in order &3 ?

  The SAP error message /SAPMP/PP_SFC027 indicates that there is more than one operation associated with a specific work center in a production order. This can occur in scenarios where multiple operations are defined for the same work center within a single order, which can lead to confusion in scheduling and execution.
  Cause:
  
  Duplicate Operations: The production order has been created with multiple operations assigned to the same work center.
  Incorrect Routing: The routing for the production order may have been incorrectly defined, leading to multiple operations being assigned to the same work center.
  Configuration Issues: There may be issues in the configuration of the work center or the routing that allow for multiple operations to be assigned incorrectly.
  
  Solution:
  
  
  Check the Production Order: Review the production order in question to identify the operations assigned to the work center. You can do this by navigating to the production order in the SAP system and checking the operations tab.
  
  
  Review Routing: Check the routing associated with the production order. Ensure that the routing is correctly defined and that there are no duplicate operations for the same work center.
  
  
  Modify the Order: If you find duplicate operations, you may need to modify the production order to remove the duplicates. This can be done by:
  
  Deleting the unnecessary operation.
  Adjusting the routing to ensure that each operation is unique to a work center.
  
  
  
  Consult with a SAP PP Consultant: If you are unsure about how to proceed or if the issue persists, it may be beneficial to consult with a SAP PP (Production Planning) consultant who can provide guidance based on the specific configuration and requirements of your system.
  
  
  Related Information:
  
  Transaction Codes: You can use transaction codes like CO02 (Change Production Order) to view and modify the production order, and CA03 (Display Routing) to check the routing details.
  Work Center Configuration: Review the configuration of the work center in transaction CR01 (Create Work Center) or CR02 (Change Work Center) to ensure it is set up correctly.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  By following these steps, you should be able to resolve the error and ensure that your production order is correctly configured.