How To Fix RSR_PE052 - InfoProvider &1 has ref. key figure &2; cannot run scenario in PAK

RSR_PE052 - Overview

• Message type: E = Error

• Message class: RSR_PE - TREX Planning Engine

• Message number: 052

• Message text: InfoProvider &1 has ref. key figure &2; cannot run scenario in PAK

What causes this issue?

InfoProvider &1 contains key figure &2 with references to another key
figure. This prevents the whole scenario from running HANA-optimized
with PAK.

System Response

As described in SAP Note 1637199, this characteristic causes the whole
scenario to run using classic IP-based planning rather than
HANA-optimized with PAK. The performance of planning actions like
executing sequences is the same as in classic BW-IP.

How to fix this error?

Either change the key figure so that it is not referential, remove key
figure &2 from your planning-enabled InfoProvider, or create an
InfoProvider copy that does not contain the key figure in order to run
HANA-optimized.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RSR_PE052 - InfoProvider &1 has ref. key figure &2; cannot run scenario in PAK ?

  The SAP error message RSR_PE052 indicates that there is an issue with a reference key figure in an InfoProvider when trying to run a scenario in the Profitability Analysis (PAK) module. This error typically arises when the system encounters a reference key figure that is not properly defined or is incompatible with the current scenario being executed.
  
  Cause:
  
  Reference Key Figure Definition: The reference key figure specified in the InfoProvider may not be defined correctly or may not exist.
  Incompatibility: The reference key figure may not be compatible with the data or the scenario you are trying to run.
  Missing Data: There may be missing or incomplete data in the InfoProvider that is required for the reference key figure.
  
  Configuration Issues: There could be configuration issues in the Profitability Analysis settings that prevent the scenario from executing properly.
  
  
  Solution:
  
  Check the InfoProvider: Verify that the InfoProvider specified in the error message is correctly set up and that