How To Fix /RPM/MIGRATION056 - No. of decision points not equal to 'No.of Phases + 1' for item type &1

SAP Error Message - Details

• Message type: E = Error

• Message class: /RPM/MIGRATION -

• Message number: 056

• Message text: No. of decision points not equal to 'No.of Phases + 1' for item type &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /RPM/MIGRATION056 - No. of decision points not equal to 'No.of Phases + 1' for item type &1 ?

  The SAP error message /RPM/MIGRATION056 No. of decision points not equal to 'No.of Phases + 1' for item type &1 typically occurs in the context of SAP's Project Management or Portfolio Management modules, particularly when dealing with migration or configuration of decision points and phases in a project or portfolio item.
  Cause:
  This error indicates that there is a mismatch between the number of decision points defined for a specific item type and the expected number of decision points based on the number of phases. The expected number of decision points is calculated as the number of phases plus one. For example, if you have three phases, you should have four decision points.
  Solution:
  To resolve this error, you should:
  
  
  Check the Configuration: 
  
  Go to the configuration settings for the item type in question. Ensure that the number of decision points is correctly defined.
  Verify the number of phases associated with the item type.
  
  
  
  Adjust Decision Points:
  
  If the number of decision points is less than or greater than the expected number (number of phases + 1), you will need to adjust the configuration to match this requirement.
  Add or remove decision points as necessary to ensure that the total matches the expected count.
  
  
  
  Review Item Type Settings:
  
  Ensure that the item type settings are correctly configured and that there are no inconsistencies in the definitions of phases and decision points.
  
  
  
  Testing:
  
  After making the necessary adjustments, test the configuration to ensure that the error no longer occurs.
  
  
  
  Consult Documentation:
  
  If you are unsure about the configuration settings, refer to the SAP documentation or help resources related to project or portfolio management for guidance on setting up decision points and phases.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use specific transaction codes related to project management or portfolio management to access the configuration settings.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance on configuration.
  Support: If the issue persists after making adjustments, consider reaching out to SAP support or consulting with an SAP expert who specializes in project management configurations.
  
  By following these steps, you should be able to resolve the error and ensure that your item type configuration is correct.