How To Fix REMPT288 - Repetitive mfg not allowed for material & &

SAP Error Message - Details

• Message type: E = Error

• Message class: REMPT - Message Class for REM Planning Table (Rel. 99)

• Message number: 288

• Message text: Repetitive mfg not allowed for material & &

What causes this issue?

To be able to create run schedule headers for the material &V1&, the
following prerequisites must be fulfilled:
The indicator, "Repetitive manufacturing" must be set in the material
master record.
You must create a production version must be created in the material
master record.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message REMPT288 - Repetitive mfg not allowed for material & & ?

  The SAP error message REMPT288 indicates that repetitive manufacturing is not allowed for a specific material. This error typically arises when you attempt to perform a repetitive manufacturing operation on a material that is not configured to support this process.
  Cause:
  
  Material Master Settings: The material in question may not be set up for repetitive manufacturing in the material master. This could be due to missing or incorrect settings in the relevant views (e.g., MRP, Work Scheduling).
  Production Type: The material may not be assigned to a production type that supports repetitive manufacturing.
  Plant Settings: The plant settings may not allow for repetitive manufacturing for the specific material.
  Status of the Material: The material might be in a status that does not permit repetitive manufacturing (e.g., blocked or inactive).
  
  Solution:
  
  
  Check Material Master:
  
  Go to the material master record (transaction code MM03).
  Check the relevant views (especially MRP and Work Scheduling) to ensure that the material is set up for repetitive manufacturing.
  Ensure that the "Repetitive Manufacturing" indicator is set correctly.
  
  
  
  Review Production Type:
  
  Ensure that the material is assigned to a production type that allows for repetitive manufacturing.
  You can check this in the production version or routing associated with the material.
  
  
  
  Plant Configuration:
  
  Verify the plant settings to ensure that repetitive manufacturing is enabled for the plant where the material is being produced.
  
  
  
  Check Material Status:
  
  Ensure that the material is not blocked or inactive. You can check this in the material master or by using transaction code MM02 to change the status if necessary.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help files related to repetitive manufacturing for any additional configuration steps that may be required.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above settings, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  MM03: Display Material Master
  MM02: Change Material Master
  C223: Maintain Production Versions
  C201: Create Production Order
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Repetitive Manufacturing Configuration: Familiarize yourself with the configuration settings for repetitive manufacturing in SAP, as this can help prevent similar issues in the future.
  
  By following these steps, you should be able to identify the cause of the error and implement the necessary changes to resolve it.