How To Fix QS710 - No time line is available for this inspection method

SAP Error Message - Details

• Message type: E = Error

• Message class: QS - QM: Master data

• Message number: 710

• Message text: No time line is available for this inspection method

What causes this issue?

No validity period has been created for this inspection method, which
differs from those already edited. Therefore no time line is displayed.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QS710 - No time line is available for this inspection method ?

  The SAP error message QS710 ("No time line is available for this inspection method") typically occurs in the Quality Management (QM) module when you are trying to perform an inspection or quality check, but the system cannot find a valid time line for the specified inspection method. This can happen for several reasons, and here are some common causes, solutions, and related information:
  Causes:
  
  
  Missing Time Line Configuration: The inspection method you are using may not have a defined time line in the system. Time lines are used to determine when inspections should occur based on various criteria.
  
  
  Incorrect Inspection Method: The inspection method specified may not be correctly set up or may not be linked to the relevant material or process.
  
  
  Data Inconsistencies: There may be inconsistencies in the master data related to the inspection method, such as missing or incorrect entries in the inspection plan.
  
  
  Versioning Issues: If there are multiple versions of the inspection method or plan, the system may be referencing an outdated or incorrect version.
  
  
  Solutions:
  
  
  Check Inspection Method Configuration:
  
  Go to the transaction code QMT1 (Create Inspection Method) or QMT2 (Change Inspection Method) to verify if the time line is defined for the inspection method you are using.
  Ensure that the time line is correctly set up and linked to the relevant inspection characteristics.
  
  
  
  Review Inspection Plan:
  
  Use transaction code QP01 (Create Inspection Plan) or QP02 (Change Inspection Plan) to check if the inspection plan associated with the inspection method is correctly configured.
  Ensure that the inspection method is assigned to the correct material and that all necessary characteristics are included.
  
  
  
  Check Material Master Data:
  
  Verify the material master data using transaction code MM03 (Display Material) to ensure that the inspection method is correctly assigned to the material.
  
  
  
  Consult with QM Team:
  
  If you are unsure about the configuration or if changes are needed, consult with your Quality Management team or SAP support team to ensure that the inspection method and time line are set up correctly.
  
  
  
  Check for Updates or Notes:
  
  Sometimes, SAP releases notes or updates that address specific issues. Check the SAP Support Portal for any relevant notes related to the QS710 error.
  
  
  
  Related Information:
  
  SAP Documentation: Refer to the official SAP documentation for Quality Management for detailed information on inspection methods and time lines.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  Transaction Codes: Familiarize yourself with relevant transaction codes in the QM module, such as QPR1 (Display Inspection Plan), QPR2 (Change Inspection Plan), and QPR3 (Display Inspection Results).
  
  By following these steps, you should be able to identify the cause of the QS710 error and implement the necessary solutions to resolve it.