How To Fix QMIP_EA230 - No inspection plan exists for specification or plan is deleted

SAP Error Message - Details

• Message type: E = Error

• Message class: QMIP_EA - QM: Inpection Planning - Insp. Plan and Master Insp. Chars

• Message number: 230

• Message text: No inspection plan exists for specification or plan is deleted

What causes this issue?

The inspection plan &V2&/&V3&/&V4& assigned to the specification &V1&
was not found or was deleted.

System Response

The system deletes the assignment from the mapping table.

How to fix this error?

Create the inspection plan again.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QMIP_EA230 - No inspection plan exists for specification or plan is deleted ?

  The SAP error message QMIP_EA230 indicates that there is no inspection plan available for the specified material or that the inspection plan has been deleted. This error typically occurs in the Quality Management (QM) module when trying to perform quality inspections or when attempting to create inspection lots.
  Causes:
  
  No Inspection Plan Exists: The most common cause is that there is simply no inspection plan created for the material in question.
  Inspection Plan Deleted: The inspection plan may have been deleted or marked as inactive.
  Incorrect Material or Specification: The material number or specification being referenced may be incorrect or not linked to an inspection plan.
  Plant or Storage Location Issues: The inspection plan may not be assigned to the specific plant or storage location where the material is being processed.
  Versioning Issues: If the inspection plan has multiple versions, the system may be referencing an outdated or incorrect version.
  
  Solutions:
  
  
  Create or Update Inspection Plan:
  
  Go to the transaction code QP01 (Create Inspection Plan) or QP02 (Change Inspection Plan) to create or modify the inspection plan for the material.
  Ensure that the inspection plan is correctly assigned to the relevant material, plant, and storage location.
  
  
  
  Check Inspection Plan Status:
  
  Use transaction code QP03 (Display Inspection Plan) to check if the inspection plan exists and is active.
  Verify that the inspection plan is not marked as deleted or inactive.
  
  
  
  Verify Material and Specification:
  
  Ensure that you are using the correct material number and that it is linked to the appropriate specification.
  Check the material master data to confirm that the quality management views are properly maintained.
  
  
  
  Check Plant and Storage Location:
  
  Ensure that the inspection plan is assigned to the correct plant and storage location where the material is being processed.
  
  
  
  Consult with SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting SAP documentation for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  QP01: Create Inspection Plan
  QP02: Change Inspection Plan
  QP03: Display Inspection Plan
  MM03: Display Material Master
  
  
  Quality Management Configuration: Ensure that the Quality Management module is properly configured in your SAP system.
  Documentation: Refer to SAP Help documentation for detailed information on creating and managing inspection plans.
  
  By following these steps, you should be able to resolve the error message QMIP_EA230 and ensure that the necessary inspection plans are in place for your materials.