How To Fix QC315 - There are no original values for inspection characteristic "&1"

QC315 - Overview

• Message type: E = Error

• Message class: QC - QM: Certificates

• Message number: 315

• Message text: There are no original values for inspection characteristic "&1"

What causes this issue?

Inspection characteristic "&V1&" requires single values. However, there
are no single measured values for this characteristic on the electronic
certificate.
Key (Inspection lot/operation/characteristic): &V2&

How to fix this error?

Either change your inspection plan or request single values for the
affected characteristics from the sender of the certificate.

Error message extract from SAP system. Copyright SAP SE.

QC315 - Details

• The SAP error message QC315, which states "There are no original values for inspection characteristic '&1'," typically occurs in the context of quality management (QM) when you are trying to process inspection results for a characteristic that does not have any original values recorded in the system. This can happen during the inspection lot processing, especially when dealing with quality inspections.
  
  Cause:
  
  
  Missing Original Values: The inspection characteristic you are trying to evaluate does not have any original values assigned to it. This could be due to:
  
  The characteristic was not defined correctly in the inspection plan.
  The original values were not recorded during the inspection process.
  The inspection lot was created without the necessary data.
  
  
  
  Incorrect Inspection Plan: The inspection plan may not be set up correctly, or the characteristic may not be linked to the correct material or inspection lot.
  
  
  Data Entry Errors: There may have been an oversight during data entry, leading to the