How To Fix QC103 - No class characteristic is assigned to master inspection char. &1

QC103 - Overview

• Message type: E = Error

• Message class: QC - QM: Certificates

• Message number: 103

• Message text: No class characteristic is assigned to master inspection char. &1

What causes this issue?

In certificate profile &V2&, the characteristic with key &V1& is shown
under number &V3&. Classification data should be read for this
characteristic. Also, a master inspection characteristic must be
assigned to the class characteristic. However, this is not the case.

System Response

All the required data cannot be found for this characteristic.

How to fix this error?

Check the data origins in certificate profile &V2&. If necessary,
assign a master inspection characteristic to the class characteristic.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QC103 - No class characteristic is assigned to master inspection char. &1 ?

  The SAP error message QC103 "No class characteristic is assigned to master inspection char. &1" typically occurs in the Quality Management (QM) module when you are trying to create or process a master inspection characteristic (MIC) that does not have any class characteristics assigned to it. This can prevent you from performing quality inspections or managing quality data effectively.
  
  Cause:
  
  Missing Class Characteristics: The master inspection characteristic you are trying to use does not have any class characteristics assigned to it. Class characteristics are essential for defining the properties of the inspection characteristic.
  
  Configuration Issues: There may be a configuration issue in the Quality Management module where the characteristics are not properly linked to the inspection characteristics.
  Data Entry Errors: There might be a mistake in the data entry or selection of the master inspection characteristic.
  
  
  Solution:
  To resolve the QC103 error, you can follow these steps:
  
  
  Check Master Inspection Characteristic:
  
  Go to the transaction code QMC1 (Create