How To Fix QC102 - No master inspection characteristic is assigned to characteristic &1

QC102 - Overview

• Message type: E = Error

• Message class: QC - QM: Certificates

• Message number: 102

• Message text: No master inspection characteristic is assigned to characteristic &1

What causes this issue?

In certificate profile &V2&, class characteristic &V1& is shown under
number &V3&. QM data should be read for this characteristic. Also, a
master inspection characteristic must be assigned to the class
characteristic. However, this is not the case.

System Response

All the required data cannot be found for this characteristic.

How to fix this error?

Check the data origins in certificate profile &V2&. If necessary,
assign a master inspection characteristic to the class characteristic.

Error message extract from SAP system. Copyright SAP SE.

QC102 - Details

• The SAP error message QC102, which states "No master inspection characteristic is assigned to characteristic &1," typically occurs in the Quality Management (QM) module when you are trying to create or process a quality inspection characteristic that does not have a corresponding master inspection characteristic (MIC) assigned to it.
  
  Cause:
  
  Missing Master Inspection Characteristic: The characteristic you are trying to use in your inspection plan does not have a master inspection characteristic defined in the system.
  Incorrect Configuration: The inspection characteristic may not be properly configured in the inspection plan or the master data.
  Data Inconsistency: There may be inconsistencies in the data setup, such as missing links between the inspection characteristics and their master inspection characteristics.
  
  
  Solution:
  To resolve the QC102 error, you can follow these steps:
  
  
  Check Inspection Characteristics:
  
  Go to the inspection plan where the characteristic is defined.
  Verify that the characteristic in question is correctly defined and that it is intended to be used in