How To Fix QA322 - No inspection points have been created for the material samples

SAP Error Message - Details

• Message type: E = Error

• Message class: QA - QM : Inspection lots

• Message number: 322

• Message text: No inspection points have been created for the material samples

What causes this issue?

The samples of the inspection lot should be assigned to specific work
centers of the inspection operations of the selected inspection plan
(The BAdI: "Creation of additional Samples" - Method "Read Existing
Inspection Operations" has been implemented).
However, no matches for the work centers were found.

System Response

No inspection points were created.

How to fix this error?

Check the inspection points of the samples and the inspection operations
in the inspection plan and change them accordingly.
Then select the inspection plan again and recalculate the sample.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QA322 - No inspection points have been created for the material samples ?

  The SAP error message QA322 indicates that no inspection points have been created for the material samples in the quality management module. This can occur during the quality inspection process when you attempt to perform an inspection but the system cannot find any inspection points associated with the material.
  Causes:
  
  Missing Inspection Plan: The material may not have an associated inspection plan, or the inspection plan may not be active.
  No Inspection Characteristics: The inspection plan might not have any inspection characteristics defined, which are necessary for creating inspection points.
  Incorrect Material Master Data: The material master data may not be set up correctly for quality management, or the relevant views may not be maintained.
  Sampling Procedure Issues: The sampling procedure linked to the inspection plan may not be defined correctly or may not be applicable to the material.
  Inspection Lot Creation: The inspection lot may not have been created correctly, or the lot may not be relevant for inspection points.
  
  Solutions:
  
  
  Check Inspection Plan:
  
  Go to the transaction code QP01 (Create Inspection Plan) or QP02 (Change Inspection Plan) and verify that an inspection plan exists for the material.
  Ensure that the inspection plan is active and has the necessary inspection characteristics defined.
  
  
  
  Review Material Master:
  
  Use transaction code MM03 to check the material master data. Ensure that the Quality Management view is maintained and that the material is set up for quality inspection.
  
  
  
  Verify Inspection Characteristics:
  
  Ensure that the inspection characteristics are defined in the inspection plan. If they are missing, you will need to add them.
  
  
  
  Check Sampling Procedure:
  
  Review the sampling procedure linked to the inspection plan. Ensure it is appropriate for the material and that it is set up correctly.
  
  
  
  Create Inspection Lot:
  
  If you are trying to create an inspection lot, ensure that the lot is created correctly and that it is relevant for inspection points. You can use transaction code QA01 to create an inspection lot.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for additional guidance on setting up inspection plans and characteristics.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  QP01 - Create Inspection Plan
  QP02 - Change Inspection Plan
  MM03 - Display Material Master
  QA01 - Create Inspection Lot
  
  
  Quality Management Configuration: Ensure that the quality management module is configured correctly in your SAP system, including settings for inspection plans, characteristics, and sampling procedures.
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to this error message.
  
  By following these steps, you should be able to identify the cause of the error and implement the necessary solutions to resolve it.