How To Fix QA235 - No inspection lot origin was assigned to inspection type &1

SAP Error Message - Details

• Message type: E = Error

• Message class: QA - QM : Inspection lots

• Message number: 235

• Message text: No inspection lot origin was assigned to inspection type &1

What causes this issue?

An inspection lot origin still has to be assigned to inspection type
&V1& in Customizing.
The result of this is that you cannot
Create an inspection lot with this inspection type
Maintain parameters for this inspection type

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Assign an inspection lot origin to the inspection type &v1& in
<DS:SIMG.SIMG_CFMENUOLQWOQL4>Customizing</>.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QA235 - No inspection lot origin was assigned to inspection type &1 ?

  The SAP error message QA235 indicates that there is no inspection lot origin assigned to the specified inspection type. This error typically occurs when you are trying to create or process an inspection lot in Quality Management (QM) and the system cannot determine the origin of the inspection lot for the specified inspection type.
  Cause:
  
  Missing Configuration: The inspection type may not have been properly configured in the system. Specifically, the inspection lot origin may not be assigned to the inspection type in the configuration settings.
  Incorrect Inspection Type: The inspection type being used may not be valid for the material or process you are working with.
  Master Data Issues: The material master or other related master data may not be set up correctly, leading to the absence of an inspection lot origin.
  
  Solution:
  To resolve the QA235 error, you can follow these steps:
  
  
  Check Inspection Type Configuration:
  
  Go to the configuration settings for Quality Management.
  Navigate to the path: SPRO > Quality Management > Quality Inspection > Inspection Lot Creation > Define Inspection Types.
  Ensure that the inspection type in question has a valid inspection lot origin assigned.
  
  
  
  Assign Inspection Lot Origin:
  
  If the inspection lot origin is missing, you can assign it to the inspection type. This is typically done in the same configuration area where you define inspection types.
  Make sure to save your changes and transport them if necessary.
  
  
  
  Review Material Master Data:
  
  Check the material master data for the material associated with the inspection lot.
  Ensure that the relevant inspection type is activated in the material master (under the Quality Management view).
  
  
  
  Check for Validity:
  
  Ensure that the inspection type is valid for the specific material and that it is not restricted or inactive.
  
  
  
  Testing:
  
  After making the necessary changes, try to create or process the inspection lot again to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like MM02 (Change Material) to check the material master or QCC0 (Quality Management Configuration) to access configuration settings.
  Documentation: Refer to SAP Help documentation for detailed guidance on configuring inspection types and understanding inspection lot origins.
  User Exits and BAdIs: If you have custom developments, check if there are any user exits or BAdIs that might affect the inspection lot creation process.
  
  By following these steps, you should be able to resolve the QA235 error and successfully create or process inspection lots in SAP.