How To Fix PO014 - Spooler: End of data (RSPOEODATA)

SAP Error Message - Details

• Message type: E = Error

• Message class: PO - Spooler message

• Message number: 014

• Message text: Spooler: End of data (RSPOEODATA)

What causes this issue?

A low-level error has occurred in the kernel portion of the SAP spool
system.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the SAP system log for messages that may indicate the problem
that has occurred.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PO014 - Spooler: End of data (RSPOEODATA) ?

  The SAP error message PO014, which indicates "Spooler: End of data (RSPOEODATA)," typically occurs in the context of SAP's spool management system. This error is related to the generation of spool requests, which are used for printing and output management in SAP.
  Cause:
  The error message PO014 usually arises due to one of the following reasons:
  
  
  End of Data: The spool request has reached the end of the data that it was supposed to process. This can happen if the data being sent to the spool is incomplete or if there is a misconfiguration in the output settings.
  
  
  Spool Request Issues: There may be issues with the spool request itself, such as it being incorrectly configured or not having the necessary data to complete the output.
  
  
  Printer Configuration: Problems with the printer configuration or the output device settings can also lead to this error. If the printer is not set up correctly or is offline, it may not be able to process the spool request.
  
  
  Data Volume: If the volume of data being processed is too large, it may exceed the limits set in the spool configuration, leading to this error.
  
  
  Solution:
  To resolve the PO014 error, you can take the following steps:
  
  
  Check Spool Request: Review the spool request in transaction SP01 (Spool Request Management) to see if there are any issues with the data or configuration.
  
  
  Printer Configuration: Ensure that the output device (printer) is correctly configured. Check the settings in transaction SPAD (Spool Administration) to verify that the printer is active and properly set up.
  
  
  Output Device Settings: Make sure that the output device settings are appropriate for the type of data being processed. This includes checking the device type and any specific parameters that may affect output.
  
  
  Data Volume Management: If the data volume is too large, consider breaking it down into smaller chunks or adjusting the spool parameters to accommodate larger volumes.
  
  
  Check for Errors: Look for any additional error messages or logs that may provide more context about the issue. You can check the application logs in transaction SLG1 for any related entries.
  
  
  Reprocess the Spool Request: If the spool request is stuck or has failed, you may need to delete it and reprocess the original transaction that generated the spool request.
  
  
  Related Information:
  
  
  Transaction Codes:
  
  SP01: Spool Request Management
  SPAD: Spool Administration
  SLG1: Application Log
  
  
  
  SAP Notes: Check SAP Notes for any known issues or patches related to spool processing and the specific error message.
  
  
  Documentation: Refer to SAP Help documentation for detailed information on spool management and troubleshooting.
  
  
  If the issue persists after trying the above solutions, it may be beneficial to consult with your SAP Basis team or SAP support for further assistance.