How To Fix PMMO_PEGDIS008 - ABAP breakpoint conditions exist but checkpoint group &1 is not active

PMMO_PEGDIS008 - Overview

• Message type: E = Error

• Message class: PMMO_PEGDIS - Pegging & Distribution relevant Messages

• Message number: 008

• Message text: ABAP breakpoint conditions exist but checkpoint group &1 is not active

What causes this issue?

To use the ABAP breakpoint function, the checkpoint group &V1& needs to
be activated using the transaction SAAB. The system tried to
automatically activate the checkpoint group but encountered a problem:
&V2& &V3& &V4&

System Response

Program execution was stopped.

How to fix this error?

Activate the checkpoint group &V1& using the transaction
<DS:TRAN.SAAB>SAAB</>. Set the radio button in the section
<ZK>Breakpoints </>to <ZK>Break</>.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PMMO_PEGDIS008 - ABAP breakpoint conditions exist but checkpoint group &1 is not active ?

  The SAP error message PMMO_PEGDIS008 indicates that there are ABAP breakpoint conditions present in the code, but the specified checkpoint group is not active. This typically occurs in the context of the SAP Production Planning (PP) or Materials Management (MM) modules, particularly when dealing with pegging and planning scenarios.
  
  Cause:
  
  Inactive Checkpoint Group: The error arises when the system encounters a breakpoint condition that is defined in the code, but the corresponding checkpoint group (identified by &1) is not active. This can happen if the checkpoint group was deactivated or not properly configured.
  Development or Testing Environment: This error is often seen in development or testing environments where breakpoints are used for debugging purposes, but the necessary configurations are not in place.
  
  
  Solution:
  
  
  Activate the Checkpoint Group:
  
  Go to transaction SE93 (Transaction Codes) or SE80 (Object Navigator).
  Check the status of the checkpoint group mentioned in the error message.
  If it is inactive, activate it.
  
  
  
  Review the Code:
  
  If you