How To Fix PM167 - The upper limit must be higher than the lower limit

SAP Error Message - Details

• Message type: E = Error

• Message class: PM - Extended Payment Functions

• Message number: 167

• Message text: The upper limit must be higher than the lower limit

What causes this issue?

The maximum balance belonging to a bank account must always be bigger
than the minimum balance that also belongs to same bank account.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Correct the maximum level.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PM167 - The upper limit must be higher than the lower limit ?

  The SAP error message PM167, "The upper limit must be higher than the lower limit," typically occurs in the context of setting parameters for measurement points or limits in the Plant Maintenance (PM) module. This error indicates that the system has detected an inconsistency in the defined limits for a measurement point, where the upper limit is not greater than the lower limit.
  Cause:
  
  Incorrect Limit Values: The most common cause of this error is that the user has entered the upper limit value that is less than or equal to the lower limit value.
  Data Entry Error: It may also arise from a simple data entry mistake where the values were swapped or incorrectly input.
  Configuration Issues: In some cases, it could be due to incorrect configuration settings in the measurement point or characteristic definitions.
  
  Solution:
  To resolve the PM167 error, follow these steps:
  
  
  Check Measurement Point Configuration:
  
  Navigate to the measurement point or characteristic where the error occurred.
  Verify the values for the upper and lower limits.
  
  
  
  Correct the Values:
  
  Ensure that the upper limit is set to a value that is greater than the lower limit.
  If necessary, swap the values if they were entered incorrectly.
  
  
  
  Save Changes:
  
  After making the necessary adjustments, save the changes and try to execute the action that triggered the error again.
  
  
  
  Testing:
  
  If applicable, perform a test to ensure that the limits are functioning as expected and that the error does not reoccur.
  
  
  
  Related Information:
  
  Measurement Points: In SAP PM, measurement points are used to monitor and record values related to equipment and maintenance tasks. Proper configuration of these points is crucial for effective maintenance management.
  Documentation: Refer to SAP documentation or help files for detailed guidance on setting up measurement points and limits.
  User Roles: Ensure that the user has the appropriate permissions to modify measurement point configurations, as restrictions may prevent changes.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or refer to SAP Notes for any known issues related to this error message.