How To Fix PLM_FMEA_APPL613 - &1 (&2) in &3: No proposal for target probability of occurrence exists

SAP Error Message - Details

• Message type: E = Error

• Message class: PLM_FMEA_APPL - FMEA - Message

• Message number: 613

• Message text: &1 (&2) in &3: No proposal for target probability of occurrence exists

What causes this issue?

The target value for the probability of occurrence could not be
determined for the list item &V1& (&V2&) in &V3&.

System Response

If an actual value was determined for the probability of occurrence, but
no target value exists because of preventive actions that were not yet
confirmed, the target value is the same as the actual value. If,
however, no actual value was determined for the probability of
occurrence, the valuation proposal for the valuation profile assigned to
the list type of the list item is taken as the target value. However,
the system could not determine a valuation proposal.
If a risk matrix is defined and it contains an axis definition for the
valuation category <ZK>probability of occurrence</>, list items with an
initial target value for the probability of occurrence in the target
analysis are not taken into account in the risk matrix.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PLM_FMEA_APPL613 - &1 (&2) in &3: No proposal for target probability of occurrence exists ?

  The SAP error message PLM_FMEA_APPL613 typically occurs in the context of Failure Mode and Effects Analysis (FMEA) within the SAP Product Lifecycle Management (PLM) module. This error indicates that there is no proposal for the target probability of occurrence for a specific failure mode in the FMEA process.
  
  Cause:
  The error can arise due to several reasons:
  
  Missing Data: The target probability of occurrence may not be defined in the system for the specific failure mode or for the associated risk assessment.
  
  Configuration Issues: The FMEA configuration settings may not be properly set up, leading to the absence of proposals for target values.
  Incomplete Master Data: The relevant master data (like risk categories or failure modes) may not be fully maintained or linked correctly.
  Versioning Issues: If the FMEA document is in a specific version that does not have the necessary proposals defined, this error can occur.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check