How To Fix PLM_FMEA_APPL139 - Resetting the confirmation of action &1 is not possible

SAP Error Message - Details

• Message type: E = Error

• Message class: PLM_FMEA_APPL - FMEA - Message

• Message number: 139

• Message text: Resetting the confirmation of action &1 is not possible

What causes this issue?

The action &V1& was canceled by the action &V2&. The confirmation of the
action cannot therefore be reset.

System Response

The confirmation of the action is retained.

How to fix this error?

Check whether the confirmation of the action &V1& should really be
reset. If it should, first reset the cancelation of the action &V1&
using the canceling action &V2&.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PLM_FMEA_APPL139 - Resetting the confirmation of action &1 is not possible ?

  The SAP error message PLM_FMEA_APPL139, which states "Resetting the confirmation of action &1 is not possible," typically occurs in the context of the FMEA (Failure Mode and Effects Analysis) module within SAP PLM (Product Lifecycle Management). This error indicates that there is an issue with the status of an action item that you are trying to reset.
  Cause:
  The error can be caused by several factors, including:
  
  
  Status Restrictions: The action you are trying to reset may be in a status that does not allow for resetting. For example, if the action has already been completed or confirmed, the system may prevent you from resetting it.
  
  
  Dependencies: There may be dependencies or linked actions that are preventing the reset. If other actions are dependent on the confirmation of the action you are trying to reset, the system may block this operation.
  
  
  Authorization Issues: The user may not have the necessary authorizations to perform the reset action.
  
  
  Data Integrity: There may be data integrity issues or inconsistencies in the FMEA records that are causing the system to reject the reset.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Action Status: Review the status of the action you are trying to reset. Ensure that it is in a state that allows for resetting. If it is completed or confirmed, you may need to take additional steps to change its status before resetting.
  
  
  Review Dependencies: Check for any dependencies or linked actions that may be preventing the reset. You may need to address these dependencies first.
  
  
  Authorization Check: Ensure that you have the necessary authorizations to perform the reset action. If not, contact your SAP administrator to obtain the required permissions.
  
  
  Data Consistency: Verify the integrity of the data related to the FMEA action. Look for any inconsistencies or errors in the records that may be causing the issue.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance related to the FMEA module and the error message.
  
  
  Contact Support: If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide insights based on the specific configuration and version of your SAP system.
  
  
  Related Information:
  
  FMEA Process: Understanding the FMEA process and how actions are managed within it can help in troubleshooting issues related to action confirmations.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional context.
  User Forums: Engage with SAP user communities or forums where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the error and take appropriate action to resolve it.