How To Fix O3292 - AGA8:Warning code 2: Density in bracket exceeds the maximum

SAP Error Message - Details

• Message type: E = Error

• Message class: O3 - IS-Oil: HPM messages (goods movements, QCI, deliveries)

• Message number: 292

• Message text: AGA8:Warning code 2: Density in bracket exceeds the maximum

What causes this issue?

The AGA c-code will use the default density; the compression factor
will be calculated.

System Response

The QCI (Quantity Conversion Interface) continues processing if you
confirm this message.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message O3292 - AGA8:Warning code 2: Density in bracket exceeds the maximum ?

  The SAP error message O3292 AGA8: "Warning code 2: Density in bracket exceeds the maximum" typically relates to issues in the handling of material master data, particularly in the context of handling density values for materials in the SAP system. This error is often encountered in the context of the SAP Advanced Planning and Optimization (APO) module or during the creation or modification of material master records.
  Cause:
  The error indicates that the density value specified for a material falls outside the acceptable range defined in the system. This can happen due to:
  
  Incorrect Data Entry: The density value entered for the material is higher than the maximum limit set in the system.
  Configuration Issues: The maximum density limit may not be configured correctly in the system settings.
  Material Type Restrictions: Certain material types may have specific density requirements that are not being met.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Material Master Data:
  
  Go to the material master record (transaction code MM03) and check the density value entered.
  Ensure that the density value is within the acceptable range.
  
  
  
  Review Configuration Settings:
  
  Check the configuration settings for density limits in the relevant customizing settings (transaction code SPRO).
  Navigate to the relevant sections for material management and ensure that the maximum density limits are set correctly.
  
  
  
  Adjust Density Values:
  
  If the density value is indeed too high, adjust it to a value that is within the acceptable range.
  If the density value is correct but the system limits are too low, consider adjusting the maximum density limit in the configuration.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help files related to material master data and density settings for further guidance.
  
  
  
  Testing:
  
  After making adjustments, test the changes by attempting to save or process the material master record again to ensure that the error no longer occurs.
  
  
  
  Related Information:
  
  Transaction Codes: MM03 (Display Material), MM02 (Change Material), SPRO (Customizing).
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  User Roles: Ensure that you have the necessary permissions to make changes to material master data and configuration settings.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in material management for further assistance.