How To Fix O3229 - QCI: test temperature and test pressure values and units are replaced

O3229 - Overview

• Message type: E = Error

• Message class: O3 - IS-Oil: HPM messages (goods movements, QCI, deliveries)

• Message number: 229

• Message text: QCI: test temperature and test pressure values and units are replaced

What causes this issue?

The system will neglect the parameters entered as test conditions for
the test density and test heating value, and use the parameters
maintained with the unit of measure for the test density or test
heating value instead. This replacement of test conditions will only be
carried out if the unit of measure entered as a test density or test
heating value unit is itself maintained in customizing ( Maintain units
of measure ) with additional descriptive parameters. This replacement
is controlled by the settings of the conversion group.

System Response

The system continues processing.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message O3229 - QCI: test temperature and test pressure values and units are replaced ?

  The SAP error message O3229, which indicates "QCI: test temperature and test pressure values and units are replaced," typically arises in the context of Quality Management (QM) within SAP. This error is related to the Quality Inspection (QI) process, particularly when dealing with inspection characteristics that involve temperature and pressure measurements.
  
  Cause:
  
  
  Unit of Measure Mismatch: The error often occurs when the units of measure for temperature and pressure in the inspection lot do not match the expected units defined in the inspection characteristics. For example, if the system expects temperature in Celsius but receives it in Fahrenheit, or if pressure is expected in bar but is provided in psi.
  
  
  
  Configuration Issues: There may be issues in the configuration of the inspection characteristics or the material master data, where the expected units are not properly set up.
  
  
  Data Entry Errors: Incorrect data entry during the inspection process can lead to this error, especially if