How To Fix LTR2_ES_CHECK193 - No rule assigned for data element '&1' in embedded specification

LTR2_ES_CHECK193 - Overview

• Message type: E = Error

• Message class: LTR2_ES_CHECK - LTR2 Checks on Embedded Specification

• Message number: 193

• Message text: No rule assigned for data element '&1' in embedded specification

What causes this issue?

In rule assignment set a transformation rule for data element &V1& is
defined, but in the embedded specification this assignment is not used.
It may be added after the rule assignment set was assigned to the
embedded specifiacation.

System Response

This results in an error.

How to fix this error?

In the tab strip RULE ASSIGNMENT remove this rule assignment set and add
it once again.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTR2_ES_CHECK193 - No rule assigned for data element '&1' in embedded specification ?

  The SAP error message LTR2_ES_CHECK193 indicates that there is no rule assigned for a specific data element in an embedded specification. This typically occurs in the context of SAP's data governance or data quality management tools, such as SAP Information Steward or SAP Data Services.
  
  Cause:
  The error is caused by the following reasons:
  
  Missing Rule Assignment: The data element referenced in the error message does not have a corresponding rule defined in the embedded specification. This means that the system does not know how to handle or validate the data for that specific element.
  
  Configuration Issues: There may be issues with the configuration of the data quality rules or the embedded specification itself.
  Data Element Not Mapped: The data element may not be properly mapped to any rules in the data quality framework.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Rule Assignment:
  
  Go to the embedded specification where the error is occurring.
  Verify if