How To Fix LTR2_ES_CHECK192 - No rule assigned for table field '&1' in embedded specification

LTR2_ES_CHECK192 - Overview

• Message type: E = Error

• Message class: LTR2_ES_CHECK - LTR2 Checks on Embedded Specification

• Message number: 192

• Message text: No rule assigned for table field '&1' in embedded specification

What causes this issue?

In rule assignment set a transformation rule for table field &V1& is
defined, but in the embedded specification this assignment is not used.
It may be added after the rule assignment set was assigned to the
embedded specification.

System Response

This results in an error.

How to fix this error?

In the tab strip RULE ASSIGNMENT remove this rule assignment set and add
it once again.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTR2_ES_CHECK192 - No rule assigned for table field '&1' in embedded specification ?

  The SAP error message LTR2_ES_CHECK192 indicates that there is no rule assigned for a specific table field in an embedded specification. This typically occurs in the context of SAP's data migration or data quality management processes, particularly when using the SAP Data Services or SAP Information Steward.
  
  Cause:
  The error is caused by the following reasons:
  
  Missing Rule Assignment: The specified table field does not have a corresponding rule defined in the embedded specification. This means that the system does not know how to handle or validate the data for that field.
  Incorrect Configuration: There may be a misconfiguration in the data quality rules or the embedded specification itself.
  Field Not Mapped: The field in question may not be properly mapped to any rule in the data quality framework.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Rule Assignment:
  
  Go to the embedded specification where the error is occurring.
  Verify if the field mentioned in the