How To Fix KM883 - Control parameters for planned postings have been converted

SAP Error Message - Details

• Message type: E = Error

• Message class: KM - Error messages for Profit Center Accounting

• Message number: 883

• Message text: Control parameters for planned postings have been converted

What causes this issue?

The control parameters for plan data in Profit Center Accounting have
been converted.
This affects plan version maintenance and the control parameters for
specific fiscal years.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the converted control parameters under "Planning -> Plan versions"
in Customizing.
<DS:TRAN.1KEE>Proceed</>

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message KM883 - Control parameters for planned postings have been converted ?

  The SAP error message KM883, which states "Control parameters for planned postings have been converted," typically occurs in the context of the Controlling (CO) module, particularly when dealing with planned postings in cost centers, internal orders, or other controlling objects.
  Cause:
  The error message KM883 is usually triggered when there is a mismatch or inconsistency in the control parameters for planned postings. This can happen due to several reasons, including:
  
  Changes in Control Parameters: If the control parameters for planned postings have been changed or updated in the system, it may lead to inconsistencies with existing data.
  Data Migration or Upgrades: If there has been a recent data migration or system upgrade, the control parameters may not align with the existing planned postings.
  Configuration Issues: Incorrect configuration settings in the controlling area or related settings can lead to this error.
  
  Solution:
  To resolve the KM883 error, you can take the following steps:
  
  
  Check Control Parameters: Review the control parameters for planned postings in the relevant configuration settings. Ensure that they are correctly set up and consistent with the existing data.
  
  
  Reconcile Data: If there have been changes to the control parameters, you may need to reconcile the existing planned postings with the new parameters. This may involve adjusting or re-entering planned postings.
  
  
  Review Configuration: Go through the configuration settings in the Controlling module to ensure that they are correctly defined. This includes checking the settings for cost centers, internal orders, and any other relevant objects.
  
  
  Consult Documentation: Refer to SAP documentation or notes related to the KM883 error for any specific guidance or patches that may address the issue.
  
  
  Contact SAP Support: If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide insights based on the specific version of SAP you are using and any known issues.
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like KP06 (for planning costs) or KPF6 (for planning internal orders) to review and adjust planned postings.
  SAP Notes: Check for relevant SAP Notes in the SAP Support Portal that may address this specific error or provide additional troubleshooting steps.
  System Logs: Review system logs for any additional error messages or warnings that may provide more context about the issue.
  
  By following these steps, you should be able to identify the cause of the KM883 error and implement a solution to resolve it.