How To Fix IDOC_ADAPTER630 - No IDoc packaging because parameter TUNING EO_INBOUND_TO_OUTBOUND = 0

IDOC_ADAPTER630 - Overview

• Message type: E = Error

• Message class: IDOC_ADAPTER - Messages for the IDoc Adapter

• Message number: 630

• Message text: No IDoc packaging because parameter TUNING EO_INBOUND_TO_OUTBOUND = 0

What causes this issue?

IDoc packaging is not used here. In the default setting, the message is
processed in two steps: once in inbound processing and once in outbound
processing. In both cases you can stop the message by using filters.
The system is set up so that outbound processing is called synchronously
after inbound processing. This means that filters are ignored for
outbound processing.

System Response

IDoc packaging is not applied.

How to fix this error?

When you configure the Integration Engine, you can change the value for
the parameter EO_INBOUND_TO_OUTBOUND in category TUNING from 0 to 1.
Note however, that this parameter is used globally and that this setting
will therefore be applied globally, too.

Procedure for System Administrators

Contact your system administrator.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message IDOC_ADAPTER630 - No IDoc packaging because parameter TUNING EO_INBOUND_TO_OUTBOUND = 0 ?

  The SAP error message IDOC_ADAPTER630 indicates that there is an issue with IDoc packaging due to the tuning parameter EO_INBOUND_TO_OUTBOUND being set to 0. This parameter controls the packaging of inbound IDocs into outbound IDocs, and when it is set to 0, it effectively disables this functionality.
  
  Cause:
  The primary cause of this error is the configuration of the tuning parameter EO_INBOUND_TO_OUTBOUND. When this parameter is set to 0, the system does not package inbound IDocs into outbound IDocs, which can lead to the error message being triggered when the system attempts to process IDocs.
  
  Solution:
  To resolve this issue, you need to change the value of the tuning parameter EO_INBOUND_TO_OUTBOUND to a value greater than 0. Here are the steps to do this:
  
  
  Access the SAP system: Log in to your SAP system where the error is occurring.
  
  
  Navigate to the Tuning Parameters:
  
  Use transaction code RZ10 to access the profile parameters.
  Alternatively, you can use transaction