How To Fix EI366 - Check scope & is selected, but no check criterion is set

SAP Error Message - Details

• Message type: E = Error

• Message class: EI - Foreign Trade: Gen. Output

• Message number: 366

• Message text: Check scope & is selected, but no check criterion is set

What causes this issue?

You have selected a check scope, but have not set any check criteria
for the detail check.

System Response

The system does not permit this entry.

How to fix this error?

Either cancel your entry or maintain the check criteria of the detail
check that correspond to the check scope.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EI366 - Check scope & is selected, but no check criterion is set ?

  The SAP error message EI366, which states "Check scope & is selected, but no check criterion is set," typically occurs in the context of configuration or data validation within the SAP system. This error indicates that a check scope has been defined, but there are no specific criteria set for that check, which leads to ambiguity in processing.
  Cause:
  
  Missing Check Criteria: The primary cause of this error is that while a check scope has been activated or selected, the necessary check criteria that define what should be validated or checked are not configured.
  Configuration Issues: This can happen due to incomplete configuration in the relevant module (e.g., Quality Management, Material Management, etc.).
  Data Entry Errors: Sometimes, this error can arise from incorrect or incomplete data entries in the relevant fields.
  
  Solution:
  
  
  Define Check Criteria:
  
  Navigate to the configuration settings for the relevant module where the error is occurring.
  Locate the section for defining check criteria associated with the check scope.
  Ensure that appropriate criteria are set for the check scope in question.
  
  
  
  Review Configuration:
  
  Check the configuration settings to ensure that all necessary parameters are correctly defined.
  If you are unsure about the correct settings, refer to SAP documentation or consult with a functional consultant who specializes in the relevant area.
  
  
  
  Testing:
  
  After making the necessary changes, perform a test to ensure that the error no longer occurs.
  Validate that the check scope and criteria are functioning as intended.
  
  
  
  Consult Documentation:
  
  Review SAP notes or documentation related to the specific module to understand any additional requirements or common issues associated with the check scope and criteria.
  
  
  
  Related Information:
  
  Transaction Codes: Depending on the module, you may need to use specific transaction codes to access configuration settings (e.g., SPRO for configuration).
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, it may be beneficial to engage with SAP support or a qualified SAP consultant for further assistance.