How To Fix EHPRC_RCS_TOOL254 - Combination of val.assmt.type &1/char. &2 does not exist (parameter &3)

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_RCS_TOOL -

• Message number: 254

• Message text: Combination of val.assmt.type &1/char. &2 does not exist (parameter &3)

What causes this issue?

Parameter &V3& specifies the mapping target value assignment type &V1&
/characteristic &V2&. Characteristic &V2& is not assigned to value
assignment type &V1& in the system.

System Response

The mapping is not transferred to database table <LS>EHPRCC_EC2MAP</>
.

How to fix this error?

To transfer this mapping to the new data model, assign characteristic
&V2& to value assignment type &V1& and run the report again.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_RCS_TOOL254 - Combination of val.assmt.type &1/char. &2 does not exist (parameter &3) ?

  The SAP error message EHPRC_RCS_TOOL254 indicates that there is an issue with the combination of valuation assessment type and characteristic in the context of the SAP Environment, Health, and Safety (EHS) module, specifically related to Risk Assessment.
  Cause:
  This error typically occurs when:
  
  The valuation assessment type specified in the transaction or report does not exist in the system.
  The characteristic (e.g., a specific property or attribute) associated with the valuation assessment type is not defined or is incorrectly configured.
  There may be a mismatch between the expected values and the actual values in the configuration settings.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Configuration:
  
  Go to the configuration settings for the valuation assessment types and characteristics in the EHS module.
  Ensure that the combination of the valuation assessment type and characteristic exists and is correctly defined.
  
  
  
  Validate Data:
  
  Verify that the data being used in the transaction or report is correct. Check if the valuation assessment type and characteristic are being entered correctly.
  If you are using custom characteristics or assessment types, ensure they have been properly created and activated.
  
  
  
  Review Customizations:
  
  If there are any custom developments or enhancements in your SAP system, review them to ensure they are not causing the issue.
  
  
  
  Consult Documentation:
  
  Refer to the SAP documentation or help files related to the EHS module for guidance on the correct configuration of valuation assessment types and characteristics.
  
  
  
  Check Authorizations:
  
  Ensure that the user has the necessary authorizations to access the valuation assessment types and characteristics.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. Provide them with the error message details and any relevant configuration information.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes in the EHS module that may help in checking configurations, such as OHS1 (for Occupational Health and Safety) or other related transaction codes.
  SAP Notes: Search for SAP Notes related to EHPRC_RCS_TOOL254 for any known issues or patches that may address this error.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify and resolve the cause of the error message EHPRC_RCS_TOOL254 in your SAP system.