How To Fix EHPRC_CP_IMDS_RES088 - Enter a non-negative decimal or integer number between '0' and '100'

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_CP_IMDS_RES - Message Class for IMDS Results

• Message number: 088

• Message text: Enter a non-negative decimal or integer number between '0' and '100'

What causes this issue?

Percentage must be a non-negative number between 0 and 100.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check your entry. Use a decimal point for decimal numbers; do not use a
decimal comma.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CP_IMDS_RES088 - Enter a non-negative decimal or integer number between '0' and '100' ?

  The SAP error message EHPRC_CP_IMDS_RES088 indicates that a value entered in a specific field is not within the acceptable range. The message specifies that the value must be a non-negative decimal or integer number between '0' and '100'. This error typically occurs in the context of the SAP Environment, Health, and Safety (EHS) module, particularly when dealing with material data sheets or compliance reporting.
  Cause:
  
  Invalid Input: The user has entered a value that is either negative, greater than 100, or not a valid decimal/integer.
  Field Configuration: The field may be configured to accept only specific types of values, and the input does not meet these criteria.
  Data Entry Error: There may have been a typographical error or misunderstanding regarding the expected input format.
  
  Solution:
  
  Check Input Value: Review the value you have entered in the relevant field. Ensure it is a non-negative number and falls within the range of 0 to 100.
  Correct Format: Make sure that the value is in the correct format (e.g., no letters or special characters, and if it’s a decimal, it should be properly formatted).
  Validation Rules: Familiarize yourself with any validation rules or constraints that may apply to the field in question. This can often be found in the documentation or help sections of the SAP system.
  Re-enter the Value: After correcting the input, re-enter the value and try to save or process the data again.
  Consult Documentation: If you are unsure about the acceptable values, refer to the SAP documentation or user manuals related to the specific module you are working with.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this error or provide additional context.
  User Training: Ensure that users are trained on the correct data entry procedures to minimize errors.
  System Configuration: If the issue persists, it may be worth consulting with your SAP administrator to check if there are any configuration issues or if the field settings need to be adjusted.
  
  If the problem continues after following these steps, consider reaching out to your SAP support team for further assistance.