How To Fix EHPRC_CP03403 - Normalization settings for parameter &1 are incorrect or missing

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_CP03 - General Messages

• Message number: 403

• Message text: Normalization settings for parameter &1 are incorrect or missing

What causes this issue?

The settings in Customizing for parameter &1 are either missing or
incorrect.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

INCLUDE NA_SYSADMIN1 OBJECT DOKU ID TX

Procedure for System Administrators

In the Customizing activity
<LS>Specify Normalization Variants</>, select the
desired normalization variant and check the additional parameters.
Ensure that parameter &V1& exists with the value maintained.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CP03403 - Normalization settings for parameter &1 are incorrect or missing ?

  The SAP error message EHPRC_CP03403 indicates that there is an issue with the normalization settings for a specific parameter in the SAP system. This error typically arises in the context of the SAP Environment, Health, and Safety (EHS) module, particularly when dealing with compliance and regulatory data.
  Cause:
  The error can occur due to several reasons:
  
  Missing Normalization Settings: The normalization settings for the specified parameter (indicated by &1) have not been defined in the system.
  Incorrect Configuration: The existing normalization settings may be incorrectly configured, leading to inconsistencies or errors during processing.
  Data Inconsistencies: There may be inconsistencies in the data related to the parameter, which could prevent the system from applying the normalization rules correctly.
  Transport Issues: If the settings were recently transported from another system, there may have been issues during the transport process that led to missing or incorrect settings.
  
  Solution:
  To resolve the EHPRC_CP03403 error, you can follow these steps:
  
  
  Check Normalization Settings:
  
  Navigate to the relevant configuration area in the SAP EHS module.
  Verify if the normalization settings for the parameter in question are defined. If not, you will need to create them.
  
  
  
  Correct Configuration:
  
  If the settings exist but are incorrect, review and correct them. Ensure that all required fields are filled out correctly and that the settings align with your business requirements.
  
  
  
  Data Validation:
  
  Check the data associated with the parameter to ensure there are no inconsistencies. This may involve reviewing the master data or transactional data related to the parameter.
  
  
  
  Transport Check:
  
  If the issue arose after a transport, check the transport logs for any errors or warnings. You may need to re-transport the settings or manually adjust them in the target system.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the EHS module for any specific guidelines on normalization settings.
  
  
  
  Seek Help from SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. Provide them with the error message details and any relevant configuration information.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO (for configuration) or EHS related transactions to access the relevant settings.
  SAP Notes: Check for any SAP Notes that might address this specific error or provide additional guidance on normalization settings.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify and resolve the issue related to the EHPRC_CP03403 error message in your SAP system.