How To Fix EG001 - Parameter &1 not in system parameter table

EG001 - Overview

• Message type: E = Error

• Message class: EG - IS-U device management

• Message number: 001

• Message text: Parameter &1 not in system parameter table

What causes this issue?

The specified parameter in the system parameter table is to be read.

System Response

This parameter is not in the table.

How to fix this error?

Check the parameter you have entered.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EG001 - Parameter &1 not in system parameter table ?

  The SAP error message EG001, which states "Parameter &1 not in system parameter table," typically indicates that the system is trying to access a parameter that is not defined in the system's parameter table. This can occur in various contexts, such as during configuration, execution of a program, or when accessing certain transactions.
  
  Cause:
  
  Missing Parameter: The parameter specified (denoted by &1) is not defined in the system's parameter table. This could be due to a configuration oversight or an incorrect reference in the code.
  Typographical Error: There may be a typo in the parameter name being referenced.
  System Configuration: The parameter may not be relevant or applicable to the current system configuration or version.
  Transport Issues: If the parameter was supposed to be transported from another system, it may not have been included in the transport request.
  
  
  Solution:
  
  
  Check Parameter Definition:
  
  Use transaction code RZ11 to check if the parameter exists in the system. Enter the parameter