How To Fix CR154 - Day & is outside of cycle length

CR154 - Overview

• Message type: E = Error

• Message class: CR - (1,099) Work Center; (100,200) Capacity

• Message number: 154

• Message text: Day & is outside of cycle length

What causes this issue?

You attempted to increase the number of shifts and exceeded the cycle
duration.

System Response

The system only accepts cycles with 1 or 7 days. Therefore, if you want
to extend your shift sequence, you can only enter a day with the number
1 or with a number from 1 to 7.

How to fix this error?

Enter a day within your cycle.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CR154 - Day & is outside of cycle length ?

  The SAP error message CR154 ("Day & is outside of cycle length") typically occurs in the context of SAP's Controlling (CO) module, particularly when dealing with cycle planning or cost center planning. This error indicates that a specific day being referenced in a planning cycle is not within the defined cycle length.
  
  Cause:
  
  Cycle Definition: The planning cycle has a defined start and end date, and the day being referenced falls outside of this range.
  Incorrect Date Entry: The user may have entered a date that is not valid for the current planning cycle.
  
  Configuration Issues: There may be issues with how the planning cycle is configured in the system, such as incorrect settings for the cycle length or periods.
  
  
  Solution:
  
  
  Check Cycle Configuration:
  
  Go to the configuration settings for the planning cycle in SAP.
  Verify the start and end dates of the cycle to ensure they encompass the day in question.
  
  
  
  Adjust Planning Dates:
  
  If the day is indeed