How To Fix CR026 - Standard value key: Parameter & has different dimension than &

SAP Error Message - Details

• Message type: E = Error

• Message class: CR - (1,099) Work Center; (100,200) Capacity

• Message number: 026

• Message text: Standard value key: Parameter & has different dimension than &

What causes this issue?

You want to change the standard value key for a work center. However
this work center is already used. That means that the standard values
that were specified by the old standard value keys can already be
maintained.
A standard value is defined via a parameter ID. Using the changed
standard value key a new standard value is defined via the parameter
ID &V1&.
This standard value has a different dimension and a different unit of
measure from the standard value which was specified using the old
standard value key via the parameter ID &V2&.

How to fix this error?

Using the where-used list select the routings in which the work
center is already used. Correct the standard values if necessary.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CR026 - Standard value key: Parameter & has different dimension than & ?

  The SAP error message CR026 indicates that there is a mismatch in the dimensions of the standard value key parameters being used in a particular context, such as in a routing or work center. This error typically arises when the system expects certain parameters to have compatible dimensions, but they do not match.
  Cause:
  
  Dimension Mismatch: The most common cause of this error is that the standard value key being referenced has parameters that are defined with different dimensions than what is expected in the context where it is being used.
  Incorrect Configuration: The configuration of the standard value key or the parameters associated with it may not be set up correctly.
  Data Entry Errors: There may be errors in the data entry for the standard value key or the related parameters, leading to inconsistencies.
  
  Solution:
  
  
  Check Standard Value Key Configuration:
  
  Go to the configuration of the standard value key in the SAP system.
  Verify that the parameters defined for the standard value key have the correct dimensions and are consistent with what is expected in the routing or work center.
  
  
  
  Review Parameter Definitions:
  
  Check the definitions of the parameters being used. Ensure that they are set up with the correct units and dimensions.
  If necessary, adjust the parameters to ensure they match the expected dimensions.
  
  
  
  Correct Data Entries:
  
  Review the data entries related to the standard value key and ensure that they are accurate and consistent.
  Make any necessary corrections to the data to resolve the mismatch.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for guidance on standard value keys and their parameters to ensure proper configuration.
  
  
  
  Testing:
  
  After making changes, test the configuration to ensure that the error no longer occurs and that the system behaves as expected.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes such as CR01 (Create Routing), CR02 (Change Routing), or CR03 (Display Routing) to access and modify routing information.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on standard value keys and their configuration.
  User Roles: Ensure that you have the appropriate permissions to make changes to routing and work center configurations.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP expert or your organization's SAP support team for further assistance.