How To Fix CM_REPORT_TEMPLATE177 - Output block not at the start of the MIC repeating group

SAP Error Message - Details

• Message type: E = Error

• Message class: CM_REPORT_TEMPLATE - Report Templates

• Message number: 177

• Message text: Output block not at the start of the MIC repeating group

What causes this issue?

An output block was defined for an MIC repeating group (master group
with instance control). However, symbol EHS_ICBCB, which denotes the
start of the output block, does not occur after the symbol that denotes
the start of the MIC repeating group. The report body and the final
report can contain different information as a result.

System Response

How to fix this error?

Place the EHS_ICBCB symbol for the start of the output block after the
start of the MIC repeating group.
Example:
<NP><(><<)>11BRG015(MIC,SAP_EHS_1027_001;*)><(><<)>01EHS_ICBCB></>
[Data for the output block]
<NP><(><<)>01EHS_ICBCE><(><<)>11ERG015></>

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_REPORT_TEMPLATE177 - Output block not at the start of the MIC repeating group ?

  The SAP error message "CM_REPORT_TEMPLATE177 Output block not at the start of the MIC repeating group" typically occurs in the context of Quality Management (QM) and is related to the configuration of inspection plans and the reporting of results. This error indicates that there is an issue with the structure of the output blocks in the report template, specifically that an output block is not positioned correctly within the repeating group of Measurement Inspection Characteristics (MICs).
  Cause:
  
  Incorrect Configuration: The output blocks in the report template may not be configured correctly. Each output block should correspond to a specific MIC and should be placed at the beginning of the repeating group.
  Template Design Issues: The design of the report template may have been altered or not set up according to the expected structure, leading to misalignment of output blocks.
  Data Entry Errors: There may be errors in the data entry for the inspection characteristics that lead to the output blocks being misaligned.
  
  Solution:
  
  
  Check Report Template Configuration:
  
  Open the report template in the SAP system.
  Verify that the output blocks are correctly aligned with the corresponding MICs.
  Ensure that each output block is placed at the start of its respective MIC repeating group.
  
  
  
  Adjust Output Block Positioning:
  
  If you find that an output block is not at the start of the MIC repeating group, move it to the correct position.
  Save the changes and test the report again to see if the error persists.
  
  
  
  Review Inspection Plan:
  
  Check the inspection plan associated with the report to ensure that the MICs are defined correctly and that there are no discrepancies in the configuration.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for guidance on configuring report templates and MICs.
  
  
  
  Testing:
  
  After making adjustments, run a test report to confirm that the error has been resolved.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on report template configuration.
  Quality Management (QM) Module: Familiarize yourself with the QM module in SAP, particularly how inspection plans and report templates are structured.
  User Forums and Communities: Engage with SAP user communities or forums where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP expert or your organization's SAP support team for further assistance.